msd

[chazer]

so i just installed msd distributor coil and ignition i was wondering if i need to keep the big red wire that goes to the poistive terminal of the coil and then back into the fuse box via wiring harness

thanks

[funwheeling]

First is it all 3 components? Ignition, Coil and Distributor?
Is the Dizzy a MSD Billet?

I have only one wire on my blaster coil to each terminal.
Just followed the directions that came with it.
I have the Offroad, blaster and billet.

[aerocorey]

If you don't intend to use a stock ignition again you can remove the wiring that is no longer used. Be sure to leave the wire going from the back of the alternator to the ignition switch intact. You can remove the splice that branches off to the old module and coil but you don't want to mess with the main part of that wire. It has a specific resistance built into it for the alternator.

[chazer]

yes all three are msd
high vibration coil
msd6a control module and probillet dizzy