Bolting up the tranny/engine

[BIGYELLOW78J10]

Could someone briefly go over the proper steps to installing a 360 to a th400 tranny?

What should be mounted first, should either be fully mounted, when does the T/C go on, etc.

I have only done this on other folks cars, and no FSJ's, so I want to do it right when I get there.

Thanks,

Daniel

Oh yeah, and where should I go to get the crankshaft bearing?

[Crazy_Jeepman]

Torque MUST be in place in the trans, ALL THE WAY BACK. Then the trans can be mated to the 360 provided it has the correct flex plate, as well as the bushing in the end of the crank, if a TH400 was behind the 360 before the spacer bushing should be in place already.