D44 high steer

[Arborigine]

I found a drawing for machining the knuckles.
They get quite a bit of green for the arms. Anyone know of a pattern or drawing of the arms out there so I can make them without doing the engineering? Actually all I need is the center-to-center distance from tre hole to the closest hole, and thickness.

[Crazy_Jeepman]

I would think that the TRE Hole to the center of the ball joint should be equal to that of the Pitman Arm TRE to center of pitman shaft. Seems all the arms I have are made that way.

[Arborigine]

seems reasonable. i can figure the thickness after I get the axle mounted under the springs.