Just finished rebuilding in my living room

[greasyjeep]

A Dana 300 with the tera low kit.
Replaced all seals and bearings as well.
It turns, but feels real tight.
Anyone else have this experience?
It seemed to tighten up as I was putting together the rear out shaft/bearing assembly.

BTT

[ March 23, 2003, 03:45 PM: Message edited by: greasyjeep ]

[greasyjeep]

Figured it out. ;)
It is amazing what a reversed bearing will do :mad: :mad: :mad:

Any reason to upgrade the yokes at this time?
They look good. I will upgrade the straps to u-bolts, but the yoke themselves?? :confused:

Anyone doing this in the future, feel free to send me a note if you need any help.

I'll be doing a flipped D300 for my TJ in a couple ofmonths and plan on doing a write up on that one.

God Bless out Troops.
Thanks