thejum57
01-21-2002, 11:18 AM
Hello everyone, I just finished putting my AT trans. and trans. case back in my J-10 in one piece. I had to replace the flexplate. My problem is now the drive shaft holes don't line up with the plate on the t-case. Can I just put the rear axle on jackstands, and turn a wheel till the line up? Also I forgot to tie up the shaft for the case before putting in the cross member, so that shaft has to come out, and placed above the member, so I can hook it up. I'll probly have the same problem, so do I just turn the whhel again? One more thing, the 4 nuts and bolts for the main shaft were crap, so I got new ones from a hardware store, grade 8, they should be o.k., right?? And I should use washers, there wern't any when I took it apart! Thanx for the advice!!!