Where to get new yokes?

[JeepsAndGuns]

I need a new 32 spline 1310 CV yoke. Where can I pick one up? I am thinking parts stores arent gonna have them.

[Crazy_Jeepman]

Need a new one or a good used one work?

[JeepsAndGuns]

Whats if off of? It is actually for my YJ's SYE. The yoke on there now is not good anymore I think. The u-joint cap is spinning and I am sure its wore the yoke a little, and I dont want to risk it. I just had a new driveshaft built and I dont want to bolt it to a wore yoke. I pulled it off a couple weeks ago to replace the seal and found out it is almost exactly the same as the one on the front output on my ford NP205. I say almost because setting side by side, the one from the NP205 was just a hair longer than the one from the SYE. I mean about or less than 1/8in. I dont think it would be enough of a diffrence. but everything else was exactly the same (other than the ford had a shield that would cover the seal)

Dont know why I bothered typeing all that out, a simple yes or no would do...lol...But yea I dont see why a good used one wouldnt work. As long as its not rusted or the cup wore like the one I have. You have one?

[JeepsAndGuns]

btt Still looking for a source.

[Crazy_Jeepman]

I have one off a Ford NP205, but I am thinking it is a 1330. I was going to check but it slipped my mind. I will try to get a look at it tomorrow. Otherwise I would check Napa and see if they can get one. Next I would check Trans shops.

[Dave]

You can try here, if you can't find it locally.

http://www.dennysdriveshaft.com/html/bolt_on_yokes.html

[JeepsAndGuns]

I'll try napa one day this week after work (if I can get off early enough)
Dave, thanks for the link.

[Micah Ross]

I have both the yolks off of my 229 but dont know if they would work for you or not