Now for the drive shaft??Dana 60 front

[KYJ10]

OK, it seems outboarding the spring maybe 1.2" on each side will work. The guy is gonna drill out and make the lug pattern standard 8 lug. So I think I will have a good setup. But what about the drive shaft. Won't the SOA change the angle on the back of the shaft? And I think my shaft will be slightly off to one side. I was told here by a 4 wheel shop that being off left to right should'nt hurt me. And Im never in 4x4 on road, so it would be strickly turn lower rpms. And who makes the best and cheapest high angle shaft? Thanks, Dennis

[KYJ10]

And I need to notch out my crossmember already, but Im assuming that it will be a must with a 60 and the front revolvers? Thanks, Dennis

[River Beast]

High angle shaft from www.arizonadrivelines.com (http://www.arizonadrivelines.com) are around $275 and max out at 40 degrees....

TALK TO STEVE ONLY...

This is about the best price you will find...

Jesse at www.highangledriveline.com (http://www.highangledriveline.com) is well known for his shafts as well but a bit more money....

[KYJ10]

What about Tom Woods shafts?

[River Beast]

Tom is ok.... just had better dealings with Steve and Jesse.....

[Rockwagon]

Tom is good but not cheep!!!! Most of his shafts start at $400.

[dnixon]

This might not be the best work but here is what I did for my crossmember.
http://www.dekonia.com/Images/ifsja/crossmember/Img_2471.jpg

http://www.dekonia.com/Images/ifsja/crossmember/Img_2472.jpg

http://www.dekonia.com/Images/ifsja/crossmember/Img_2473.jpg

[rockjeep44]

Hey that looks familiar :D