Shifters for doubler and tranny in

[blt2krl]

Well I got the shifters in. I need to get another boot for one of the shifters but everything else is in.
http://www.planet4x4.net/phpBB2/album_pic.php?pic_id=1600
http://www.planet4x4.net/phpBB2/album_pic.php?pic_id=1599
Drivlines will be in on Tuesday. :D I decided to goa 1410 up front and a 1410/1350 on the rear. I didn't want to chang out the yoke on the 14 bolt.

[Stuka]

ooh.. lots of shifters smile.gif I love the look of having half a dozen shifters on the floor. All you need now is a PTO added on and a shifter for it smile.gif

[rstep]

Wow them some shifters,looks great.

[Slim]

WOW man that ROCKS ,,,, great set up

[Bob Barry]

Do you have a shot from underneath?

I'm in the midst of hooking up my shifters for my twin-sticked NP205.

The front output was no problem; I just used a Chevy 4wd shifter and a length of threaded rod.

The rear output is a pain, because it is RIGHT under the stock pivot, but it's not close enough to hook to the shifter directly. I tried to fabricate a small link from angle-iron, but there's too much play in it and not enough travel on the shifter.

I'm looking for neat ideas; my next option will be to weld a tab on the bottom of the stock shifter in-line with the output rail, and see if that works better.

This is DEFINITELY something I should have worked on the two years that transfer case was sitting in my garage...