3" DPA and End Links?

[woodstock]

I just installed a Rough Country 3" Suspension Lift on the front of my 88 GW and a 4" BDS on the rear. Looks good because RC kit was new, BDS springs were used. Rear end is just slightly higher than front so fender-tire spacing is about equal. Anyway...I wanted to add a 3" drop pitman arm and 3" extended swaybar endlinks. I called Rough Country and they said they only have those things for up to an 86 GW. Anybody know if pitman arms and swaybar endlinks are interchangable between and 86 GW and an 88 GW?

[ December 26, 2003, 11:10 AM: Message edited by: woodstock ]

[The Anti-Chrysler]

I think they're all the same. They might not have a verified listing past '86. BJ's has quick-disconnect extended links for lifts; I had to make some up using 2 sets of old one's, since I didn't need disconnecting ones.

[The Anti-Chrysler]

Oh yeah, all pitman arms are definitely the same, and they will probably come in a 4" drop, not 3"

[woodstock]

Great! Thanks Jason!

[The Anti-Chrysler]

No problem, BTW, the 4" DPA should work fine for you. On mine with a 4" lift, the 4" DPA still leaves the drag link at a slight angle, so with a 3", it should work great.

[woodstock]

Just ordered a 4" DPA from BJ's. Should work great!