J20 project
05-03-2002, 04:38 PM
Being the inventive type, I was looking for a way to install all of my new switches, etc. w/o drilling a bunch of holes in my dash. Well I helped build a new gas tank on 64 travs willys and had to modify it by cutting a corner off of it. Had the corner laying around for a while. Happened to look at it and it was about the right size to mount about 8-10 different switches into it. This got mounted to the floor hump corner just below where you would touch with your right hand in front of the seat. I mounted a fuse gang block inside powered w/ 10ga wire. It now houses my winch, elect fan, tranny switch, Battery solenoid, fuel switch, and choke cable, w/ room left for lightswitches. J20 project