summit 272/282 cam and lifter questions

[WillyPete]

anyone got it? how do you like it compared to the stock cam?

just wondering if i should keep my stock cam or get a replacement

i can get to the lifters just by removing the intake manifold, right? it's not necessary to rip off the water pump, front cover, etc?

thanks smile.gif

[porkchop]

What is the part number on this cam? Also you do need to take off the water pump and the timing chain caver and timing chain to get the cam out. But to get to the lifters all you need to do is take of the intake.

[WillyPete]

part number 10301 from PAW
from summit it's PN SUM8600

advertised 272/282 duration with .472/.496 lift at valve and 122 degrees of lobe seperation

[Crazy_Jeepman]

I run the Summit 8600 cam. It does a good Job, it is not a stump pulling type cam. It will give you decent low end and a good mid range. For a daily driver it is fine. All depends what you want your rig to do. Burn the tires off & snap your neck never happen. It is just a good all around cam. ;)