I am giving up on part time install !!!!!!!!!

[seadog]

I also gave up on part time install in quadratrac t-case.The directions do not explain everything that needs to be done and leaves you wondering about a couple little things that could be crucial.When I installed the new parts I didnt see room for the annular bearing and the seal both.I let my tranny guy mess with that set of junk instructions.After running gear is done hopefully I can run with the rest.That new shaft-------Nothing holds it in!!I can just pull it out,Yoke,shaft and all.Thumbs up to you fellas who did this yourself and thought it was simple.I would rather take a beating than try and take out another c-clip that holds that bearing in!! :mad:

[jeepguzzi]

Do you have low range?? If you do, I think the sun gear inside the planetaries holds the shaft. If you don't, then there is a keeper like a snap ring affair I think that goes in to hold that side in.