molding around wood repair

[sjp88grndwagon]

I have a slight warp to the front drivers side molding around the wood grain. It is raised about 1/2 inch and looks like it will start to come off. What is the best way to anchor this down?

[OBX-AUTOMOTIVE]

Originally posted by sjp88grndwagon:
I have a slight warp to the front drivers side molding around the wood grain. It is raised about 1/2 inch and looks like it will start to come off. What is the best way to anchor this down?WOOD SCREW?? :rolleyes: :D

[OBX-AUTOMOTIVE]

JUST KIDDING!!!!!!!!! I'M NOT SURE,BUT YOU COULD TRY DOUBLE FACE TAPE.....OR REPLACE WITH NEW CLIPS! smile.gif

[sjp88grndwagon]

I would just replace the whole trim but cant find any, who sell's it?

[4DWUDS]

Heat up the trim with a heat gun to soften the trim ,apply some "Liquid Nails" and push back into place, keep applying pressure untill the glue sets. This make take a while so either get a clamp on it or a tell a drunken sailor its a light pole and have him lean against it. Carefully Trim any excess glue with a razor and yer done.

[sjp88grndwagon]

Thanks I think Im going to go for the liquid nails. The lifting of the molding can be seen at
http://www.simbur.com/88wag1.htm
sugestions ?

[82wagonlimtd]

That site that was posted has some I believe, but it is kinda pricey.....

as in each fender is like $125 for the trim.

Andy