PDA

View Full Version : Now I'm mad -

billybooster
10-12-2003, 02:15 AM
Above my ATF pan, drivers side, is an electrical connector - i'm guessing for reverse. It's a plastic housing that swivels in a hole and belches ATF.

How does this come out so I can fix it? It's very loose with lots of play.
PlumCrazy
10-12-2003, 02:21 AM
Billy and his electrical demons...sorry no help at this end today. smile.gif
billybooster
10-12-2003, 02:30 AM
thx though for last week's help!
Chevelleguy
10-12-2003, 02:37 AM
This is for your kickdown switch. I am assuming you have a TH400. You must remove the pan to unhook the connector. It is held in with two plastic ancors on either side and is sealed with an o-ring.
billybooster
10-12-2003, 02:44 AM
I guess I have to drop the pan to do the seal around the dip stick?
Chevelleguy
10-12-2003, 02:53 AM
No. The tube comes out the top and there is either an o-ring around the tube or a rubber boot that goes into the case.
billybooster
10-12-2003, 02:55 AM
That's encouraging! Is the dip stick attached with a clip, screw, or just 'thrust into the hole?? Thanks Chevelleguy for this!
Chevelleguy
10-12-2003, 02:57 AM
Held in by one of the trans to engine bolts. Anytime.