scotty
01-13-2003, 02:08 PM
FSJeeper,was that you that said that the dodge 435/203 uses the 23 spline input and circle pattern?
if so,are you %100 sure?
if so,then i may have a new game plan :D
ive located a 1980 dodge granny 4 speed/transfer case on ebay.
the seller says the tranny is model unknown,but definately has a granny 1st.should be np 435,yes? looks like it from the pic,but im not as familiar with it as i am the sm465 or t18.
seller thinks xfer is a 203,and from the pic,he is right smile.gif
depends on location and the cost of shippig if its too far to pick up,but a friend has a pto that should bolt to the 435,and i could run my d300 behind the 435 till i either a) break the tailshaft ;) or b) accumulate the parts to put my 205 behind the range box.
sounds like a good plan to me :D
ur thots? smile.gif
[ January 13, 2003, 09:09 PM: Message edited by: scotty ]
if so,are you %100 sure?
if so,then i may have a new game plan :D
ive located a 1980 dodge granny 4 speed/transfer case on ebay.
the seller says the tranny is model unknown,but definately has a granny 1st.should be np 435,yes? looks like it from the pic,but im not as familiar with it as i am the sm465 or t18.
seller thinks xfer is a 203,and from the pic,he is right smile.gif
depends on location and the cost of shippig if its too far to pick up,but a friend has a pto that should bolt to the 435,and i could run my d300 behind the 435 till i either a) break the tailshaft ;) or b) accumulate the parts to put my 205 behind the range box.
sounds like a good plan to me :D
ur thots? smile.gif
[ January 13, 2003, 09:09 PM: Message edited by: scotty ]