J -truck semi-float 60

[GruntDoc]

having no luck on finding spline count or any confirmed info on this axle.
spline count?
c-clip?
worth it as an up grade from a dana 44?

thanks,
Doc

[Panther]

There is plenty of info on that axle here: http://panther4x4.com/Dana60-2/

It's about as much info as you can find online including PN#s, trac width, discs brakes, etc

[GruntDoc]

Originally posted by Panther:
There is plenty of info on that axle here: http://panther4x4.com/Dana60-2/

It's about as much info as you can find online including PN#s, trac width, discs brakes, etcdude you rock, i was wondering if it was worth pulling for my CJ but now seems a very viable choice

[GruntDoc]

btw where did you have it shortened?

[Panther]

I had it cut/replined at http://www.mitchelldifferential.com/

Went with them because they are local but it would have cost the same if I had moser ship it. Had a front shaft shortened by them a few years ago. If you lose that link it's on the "install" page.