Spline Counts QT & D20 X-Case

[WINGO]

What are the spline counts on the output shafts for QT and D20 X-cases?

I am looking to connect my D300 to my D 44 front axle.

If drive shaft lenghts are known, those would be helpfull too.

Thanks!

[ May 16, 2002: Message edited by: WINGO ]</p>

[Langdon]

You mean the case outputs? I know the QT had both 10- and 26-spline outties. I believe this is true for the D20 as well, I see both offered in catalogs. The D20 I have is 10-spline (older, it was mated to a TH400). Comparing the pieces I have laying around, the QT and D20 yokes appear identical...when I go to D20 I need to see about using the QT yoke and double cardan front shaft :cool: