Motor Mounts?

[tjosha]

I'm going to start accumulating the needed parts for my drivetrain swap. Do any of you guys remember what motor mounts you used when swapping to a big block Chevy?

[Knucklehead]

I'm getting ready to do this swap too (small block instead). I only know that the sb and bb share the same motor mounts. You can get motor mounts from Advaced Adapters. I think that for the money I will be fabricating my own as I need to mount the motor/tans/transfer off centered to the pass side to ease drive shaft angles to the rear diff.

What are you using for the trans/transfer?

From what I here the chevy drive train is a simple swap, but I would like more details/pictures before I get into this as well.

Jon

[tjosha]

I'm doing a complete swap from a '84 Chevy 1-ton. It has the 454/Turbo 400/205 and Dana 60 front and 14 Bolt rear. Are you keeping your stock axles?

[Knucklehead]

Yeh. That is why I'm putting the 327 off center to the pass side. I got 3.54's, which is a good ratio for general use. Just 31x10.50 for tires. This is a daily driver.

I will be looking for a trans/np208 combo. not sure yet if I want a 700R4 or a sm465.

Your's sound pretty heavy duty. That is how I would like to do my J10. Or at least us a 60 in the rear.