Buick 350 headers

[alex.t]

I was wondering if anyone out there was running headers on their Buick powered waggys. If you are, where did you get them? Will headers for a Skylark work?

Also does anyone know about body armor for wagoneers. Also looking for aluminum diamond plate door panels.

[Tad]

First off, welcome to the board alex.t, fair amount of Buick 350 folks here but I do not recall anyone running headers, could be wrong though.
We have a little Buick 350 email list going, do a search for the post and you're more than welcome to hop on the list.

oops, found it...
Buick 350 Email List (http://www.ifsja.org/cgi-bin/ubbcgi/ultimatebb.cgi?ubb=get_topic;f=3;t=006097;p=1)

[ January 09, 2003, 08:57 AM: Message edited by: tadsal ]

[james1414d]

im building some as we speak. bought a flange kit from TA. car headers will interfere with t-case, driveline. coulda cut up some car headers but i have a problem spending 325$ just to hack em.

[kidatforty]

My engine is out right now, but next week I'm re-installing and adding headers. I got them from TA Performance. $269. I anticipated a problem with clearance at diff. etc.. I am fully prepared to modify as needed. I will let everyone know how it goes.

[curt]

Kid,

Did you get the shorties from T/A Preformance or the car headers?

[kidatforty]

Shorties weren't available except for the big blocks. I went with the standard headers they offered. They said they didn't think fitting to a wag. would be a problem. I was prepared to fabricate my own, so if I have to modify a little I am way ahead. I should have my block back next week, so we'll know then how it all fits.