PDA

View Full Version : Truck load of Jeep Parts in So. CA.


Banchee
01-20-2012, 10:44 PM
I have a good deal for someone that lives in or near the South bay area of Southern California. I have a bunch of Jeep parts that I no longer want sitting in my shop. One price takes everything listed below.

Model 20 Jeep CJ rear axle assembly (Drum to Drum)
FSJ Transmission cross member (from 76 J10)
Q/trac differential units (3 of them)
Lower steering column shaft with u/joint (FSJ)
Several FSJ front shock mount frame brackets (FSJ)
J Truck gas tank strap (from 76 J10)
Drive shafts (front and rear) (from 76 J10, 400 TH, Q/Trac)
Drive shaft (NOS) (rear) for Jeep CJ
373 ring and pinion set for Dana 60 (good cond.)
Diff covers: (1) Dana 44, (1) Dana 60, (1) GM 14 Bolt (FF)
Front wheel hubs (2) (6 Lug FSJ)
Q/Trac vacuum line set (steel lines that run up the firewall) (FSJ)
Set of (5) 15X8 6 Lug Factory 70's ara FS Jeep slot steel wheels (Clean wheels)
(3) 15X8 6 Lug FSJ white steel spoke wheels (Need to be sand blasted)
OE Goodyear A/T Tracker tire (Chief) (No to low miles, no weather cracks)
Hood latch bar assem. (razor style)
Door hinges (FSJ) (2 pair) (1 pair has brand new bushings) (1 pair need bushings)
Rear window for J10 or J20 (Non slider)
Misc. stainless steel moldings: Windshield, door, tailgate, Etc. (FSJ)
Wiper motor (FSJ)
Sun Visors, nice cond. (from 77 Cherokee Chief)
Leather warped (Gray) steering wheel for 91 Jeep XJ limited
(NOS) 2 door set of stainless steel vent visors for J truck or Cherokee
(NOS) Factory Jeep (FSJ) door window sweeps (2)
Insterment cluster bezel (wood grain overlay missing len’s) (from Grand Wagoneer)
Wind wing glass with lower molding, latch and good weatherstrip (left side, from 76 J10)


This is a package deal! I want it all gone so I have priced it very fairly. There’s a lot of good parts here and someone can make some money on this stuff by selling it off separately. Most of these parts came from low mileage Cherokees and J trucks that were parted out about 16-17 years ago. These parts have been stored inside my shop since then. This is not a bunch of rusted crap that has been sitting in a field!
The price is $250.00 for everything listed above!

Thanks for looking!!

itsaproblem
01-20-2012, 11:32 PM
Wish I lived closer, lots of good parts here. If no one takes the lot and you part out I'll pay & put to good use in the following:
Set of (5) 15X8 6 Lug Factory 70's ara FS Jeep slot steel wheels (Clean wheels)
Misc. stainless steel moldings: Windshield, door, tailgate, Etc. (FSJ)
(NOS) 2 door set of stainless steel vent visors for J truck or Cherokee
(NOS) Factory Jeep (FSJ) door window sweeps (2)
Wind wing glass with lower molding, latch and good weatherstrip (left side, from 76 J10)

Thank!

Banchee
01-31-2012, 09:09 AM
Wish I lived closer, lots of good parts here. If no one takes the lot and you part out I'll pay & put to good use in the following:
Set of (5) 15X8 6 Lug Factory 70's ara FS Jeep slot steel wheels (Clean wheels)
Misc. stainless steel moldings: Windshield, door, tailgate, Etc. (FSJ)
(NOS) 2 door set of stainless steel vent visors for J truck or Cherokee
(NOS) Factory Jeep (FSJ) door window sweeps (2)
Wind wing glass with lower molding, latch and good weatherstrip (left side, from 76 J10)

Thank!

Feel free to PM me an offer on those things if you would like to. Just know that the wheels will be costly to ship to the East Coast.

Thanks
Dennis

Dion
01-31-2012, 12:21 PM
Where in So. Cal are you located?

Heavy_Metal_Thunder_81
01-31-2012, 12:51 PM
Where in So. Cal are you located?
Ditto.

Banchee
01-31-2012, 08:04 PM
Ditto.

The parts are stored at my shop in Lomita (Harbor City/South Bay area). Near PCH and Western.

Dennis

NoRegrets024
04-05-2012, 09:57 AM
do you still have the parts

Banchee
04-06-2012, 01:03 PM
do you still have the parts

Yes I do!
:cool:

NoRegrets024
04-07-2012, 12:09 PM
awesome do u know if the qt's work??if so i would like those cause mine is shot

Banchee
04-07-2012, 11:10 PM
awesome do u know if the qt's work??if so i would like those cause mine is shot

There are no "qt's" on the list! Only the differential units (3 of them) that are inside of a Quadratrac transfer case.

The differential units were all working when they were removed to install part time kits.

:cool:

Chumley360
04-12-2012, 11:51 AM
PM'd

Banchee
04-12-2012, 11:30 PM
PM'd

Back at ya!!