2" body lift

[blt2krl]

I plan on putting my two inch body lift on the waggy tomorrow. I was wondering if there was any problems with the install that others may of had. The only extension I had is for the tranny shift linkage. The gas filler tubes look like the should be okay with the install. Any insight would be appreciated.

[joe]

You might(?) need to relocate the radiator/fan shroud?

[River Beast]

Check out my site for details on the bodylift install...

Very helpful to remove the bumpers first to clear the body lip that is under the top lips of the bumpers...

[River Beast]

<BLOCKQUOTE>quote:</font><HR>Originally posted by -joe:
You might(?) need to relocate the radiator/fan shroud?<HR></BLOCKQUOTE>


Ditto.... just re-drill new holes in the radiator support brackets on each side 2" higher to drop the it to the correct location and reassemble... piece of cake... watch for clearance of the tranny cooling lines under the fan and shroud...

[blt2krl]

Thanks for the input guys. I don't have to worry about the fan shourd becasue the PO took it off. Well wish me luck.

[fas2c]

You might not need to extend your linkage. Crawl under and check it out. My waggy didn't really need the extention, although I put it in place to be on the safe side. You maybe able to slide the linkage to where you need it.
Good luck and don't spare the Blaster ;)
fas2c

[jeepbob]

Do lower the rad as it keep the thing much cooler in the summer as well as keeps the proper clearence between the fan and hoses.

[Stolen76]

I've been hunting one of those, don't want the 3" I keep finding. Do you have a maker and part number ? Any help would be appreciated !