80's J10 sportside - part out (in Connecticut)

[TheDude]

I am parting out a rough J10 sport side that was purchased for a few misc pieces and parts. Send requests for anything of interest and I will post what is spoken for and sold below. For an an almost instant response send an email to 'rook861@yahoo.com' concerning misc parts. At this time I am not interested in shipping, so everything is local pickup only. Prices and pictures of parts will be posted in further detail as requested. Thanks guys.

:fsj:

RM

1981 J10 sport side - sienna orange in color
258 / t176 / 208
D44 FR / AMC20 RR
LT Tan Interior

http://a3.sphotos.ak.fbcdn.net/hphotos-ak-ash4/196489_1357916263140_1088490215_31154151_4772947_n .jpg


http://a7.sphotos.ak.fbcdn.net/hphotos-ak-snc6/206773_1357916503146_1088490215_31154153_3455644_n .jpg

-For Sale
Muscle grill $75
Bed $80 (has some rot)
Fuel tank with sending unit $50
Dana 44
AMC 20
258 (complete / carb to oil pan)
T176
NP208
Bed


-Spoken For / Sold / Gone...
Stainless cab trim
Exterior bed light
FR windshield & gasket
Steering column / steering shaft
Aluminum running boards
Entire Steering system (Steering wheel to box only)
Rear fenders (rough/broken, good for patches)
Hood (has some rot)
Cab
Bucket seats (need a thorough cleaning)
Tires / Wheels & center caps
Both Doors
Both front fenders
RR slider

[chr1s]

pm/email sent

[TheDude]

Pm returned!

RM

[Chris_Hoyt]

If you decide to ship anything I need the chrome trim from around the back of the cab. I'd probably take the rear cab light too...If you decide to.

[TheDude]

Chris, I will let you know if I get into shipping any items. Thanks.

RM

[JeepWrencher]

Same thing Chris said, if you are willing to ship there are parts I'm willing to buy. Let me know if it changes.

[twisted frame]

TheDude, we already emailed back and fourth about my interest in the windshield. I'm just posting up to put myself in line for the windshield - and bump for you.

[TheDude]

Bump

The bucket seats are now free, as their respective mounts are partially rotted. The seats need a liberal cleaning, but will do for the price!

RM

[Chipflyer]

Interested in the Cruise control setup if it has it and you decide to ship.

Jeff

[TheDude]

Top

Chipflyer, It does not have cruise. Thanks for the inquiry!

RM

[chelvis]

RM, do you have the headliner? I also need part of the heat system, believe it is the blower motor housing underneath the dash.

I am down in NJ and could take the drive up to pull the parts myself.


Thanks in advance, Tom

[TheDude]

Sure do. I have the headliner which is a cream color and the entire heater system. Shoot me a PM for the specifics and what not. Thanks!

RM

[Houlie]

is the rear section of the frame available......looking from the cab/bed area back?

[tazldr]

If you consider shipping, I could really use the Gas Tank protective plate with or without the mounting straps.

Tony

[TheDude]

Houlie - Sorry, but that section of the frame was in terrible shape and has already met its fate.

Tazldr - Unfortunately the tank was previously removed and did not come with a skid or factory straps... I am sure they most likely rotted out like most of the parts on this rig.

Thanks for looking and for the inquiries.

RM

[elij10travis]

what about the driver side fender how much i live in maine isnt too far pa all expensis for reasonable price

[TheDude]

Elij10travis - Unfortunately the driver side fender has already sold. I just didn't get around to marking it down. The passenger side was exceptionally rough and will be used for patches. Thanks for inquiring!

RM

[TheDude]

TOP

RM

[TheDude]

TTT

RM

[wiley-moeracing]

would be interested in the grill if you want to get into shipping to az thanks tim

[oldsixinarow]

How's the tailgate? I could pick up in a week or two...

[TheDude]

The gate is actually in fantastic shape. Not much left other than the drive train, cab and a bunch of small odds and ends.

RM

[TheDude]

The tailgate has sold. Many other great pieces and parts remain! PM or inquire now before they walk out on me. :D

RM

[dano73]

Grille still available? How far are you from the bridgeport ferry?

[Mars]

what's the bed look like?
pics to Yama@cinci.rr.com

[TheDude]

The fenders were a complete write off, but the rest of the bed is salvageable. I can get you pictures tomorrow. Thanks!

RM

[TheDude]

Grille still available? How far are you from the bridgeport ferry?

The grill is still available and I would guess about a half an hour. Shoot me a PM if you are interested.

RM

[dano73]

PM Sent

[TheDude]

All PM's returned. Thanks for looking / inquiring guys!

As of now the grill is pending / sold.

RM

[Headhoncho]

Do you still have any parts left over? Looking for the aluminum spacers (about 1 1/2") that go between the bed and the frame. There should be six of them.


Thanks, JR

[TheDude]

BTT

I still have the sportside bed, the cab and the entire drive train (engine / transmission / transfer case) as well as the axles. Most of the dash and the steering column along with its wheel are present. Unfortunately it needs to make its leave before the end of fall otherwise it is getting the axe. Thanks guys.

RM

[TheDude]

TTT

The front and rear axles are still up for sale ($250 obo FR/RR) along with some other smaller pieces and parts. Come and get it! Thanks guys.

RM

[polarfire]

Are you shipping anything?

[datil_peppers]

I have a 79 J20, I'm looking for seats and doors.

[TheDude]

Unfortunately I do not have doors and shipping is dependent on what you need. Most of everything remaining is quite large and heavy. Shoot me a PM for what you are looking for. Thanks!

RM

[barbersteve1]

Do you have the end caps to the stepside bumper? Thanks Steve

[Big J10 man]

I am interested in the gas tank with sending unit. Does it work and does it leak> If I have to drive to Conn. I will.
Thanks,
Mike

[Logs0012]

could you snap me a picture of the steering column setup? I'm very interested in all the steering stuff pending pictures

[Big J10 man]

Hey Dude I sent you a message earlier dont know if you received it though. I'm interested in the fuel tank. Are you able to ship I'm in Maryland 21629. If not I guess I'll have to travel.
Thanks,
Mike

[TheDude]

All messages and inquiries have been replied to. Thanks for looking and asking guys!

RM

[mt0264]

is their any way to see the P/N on the bell housing, I am looking for one for a 83 with the same motor and trans you got,
Thanks mike
mt0264@aol.com

[TheDude]

I can try to get an image of it for you. Thanks for looking!

RM

[TheDude]

The cab needs to leave in the next week or two for a low price of FREE. Otherwise she is going to the scrap yard. Thanks for looking guys.

:fsj:

RM

[Hippie Metal]

PMd

[JeepBountyHunter]

Oh man, if I had a way to get that bed here, 80 bucks too....o'well...good luck.

[TheDude]

PM's replied.

Jeepbountyhunter, ohio really isn't all that far... :thumbsup:

RM

[TheDude]

Last call for a brow-less cab... My sawzall is mighty hungry.

RM

[TheDude]

Cab's gone, but many nice parts remain!

RM

[a1500ram]

Just sent you a pm.

[TheDude]

Pm's replied.

RM

[83sdc]

can you give us some kinda idea as to whats left?

[a1500ram]

Another PM sent

[TheDude]

83sdc, If you check on the first page the top list will give you an idea of what remains. Otherwise just shoot me a pm for what you are looking for.

All PM's returned. Thanks!

RM

[TheDude]

The bed and remnants of the cab/body are up for grabs for FREE. I need the room and these parts have to leave. I also still have the axles and the complete drive train. I would like to see this stuff go to a good home before it goes to the scrap yard. Thanks for looking.

RM

[azjeeper]

Your PM box is full.
Was wondering if the tail light lenses are available?
Thanks

[TheDude]

Sorry about that, I just emptied it. Unfortunately the tail lights never made it to me with the truck.

RM

[CoastGuardTruck]

I'd love to come pick some parts..but no car till next year =/

[TheDude]

Bump

RM

[TheDude]

Bump

The drive train, axles, bed and numerous patch panels still remain. This stuff needs to make its way out, or some of it will be going to the local scrap yard.

RM

[TheDude]

Last call on a FREE bed and cab patch panels before they are moved to the recyclers.

RM

[TheDude]

Last week for the cab and patch panels. The Dana 44 is gone and the AM20 rear remains. Come and get it!

RM

[TheDude]

Patches and cab remnants gone along with the am20.

All that remains is the T176 and the np208 along with the 258.

RM