75 cherokee S

[J10Truken]

I'm looking at a '75 Cherokee S with a 360 motor. Does anyone know what kind if tranny they put in these models? Also the case is a quadra-trac with a knob in the glove box. Is this a single speed transfer case? I can't find any other levers.

[porchpiggy]

It's a GM TH400 with an AMC engine bolt pattern. The high/low lever for the TC is under the driver's seat close to the transmission tunnel if it has it.If it ain't there it prob doesn't have low range.

[Bob Barry]

It has the TH400 tranny.

The glove-box switch is for the E-drive (locks the driveshafts together). If your case has the low-range, there would be a small lever on the left-side of the tranny-tunnel, just under the right-corner of the driver's-seat. If there's no lever there, and there's no cable-operation on the dash for the low-range, and you look on the back of the unit underneath the truck and there's a big round flat plate centered on the back of it, then it probably doesn't have a low-range. One can be added easily-enough, though.

[orangecherokee]

that's what mine is and i suggest if it is yours do away with the cable pull and rig up a lever system! i had to on mine and man was it a pain to find another. what really sucks is when you have to go underneath with a 9/16" everytime you want low range. but bob is correct, there should be a cable pull on the lower right hand corner of the dash beside the glovebox.

[J10Truken]

Thanks for all the input guys. I think i'm going to go ahead and get this rig as it only has 118k original miles on it and the a/c even works. Is $900 too much for this rig?