PDA

View Full Version : $5.00 list in SC


Jeepguyp
02-13-2011, 04:27 PM
Stuff I yanked from the crusher bound 83 Gwag (and the 81 Cherk before it) $5.00 anything below

Headlamp buckets and retainers (per side)
Cruise pod and accel link\cable(83)
washer jugs
digital quartz clock from 83--unknown if works
intermediate speedo cable(44 INCHES)
vacuum pod
cruise servo (81)
a few sidemarker lens bezels

Jeepguyp
02-14-2011, 11:08 AM
Add an antenae mast and bezel

Jeepguyp
02-14-2011, 03:56 PM
Im listing this stuff too...priced different

Brake proportional valve(83) - $20.00
Air cleaner-rectangular snout- $20.00 w\lid
driver side wiper ARM with strut\clip $8.00 factory? gold paint
Passy wrap-around tail light lens $15
Crank and w-pump pulleys. $15 either
wiper motor (81) $10
V8 fan\clutch (non thermal)-$15

Jeepguyp
02-15-2011, 07:49 PM
2bbl 360 + 727 minus rear output adapter..sitting here where I pulled them. can be had cheap. 360 ran but had rattle....bearings? make an offer...SC 29306

sld
02-16-2011, 09:17 AM
I have a 81 WT. Do you have everything for cruise control?

Schlagger
02-16-2011, 09:20 AM
Put me down next in line for the cruise control stuff

Jeepguyp
02-17-2011, 10:40 AM
I think a 79 has a bellows on the intake... thats different than the pod off this 83. its like the 80s Chrysler vehicles, except the working"exciter" part is seperate. (i dont have that)... and i think the 81 had the "box" on the fenderwell(and a servo at the intake) like my 77 does.

What I have is the "box"from the 81, and the servo pod w\cable from the 83

Jeepguyp
02-17-2011, 10:44 AM
I also pulled a single roof rack side, and the 3 chromed plastic strips that went down the roof. Nice shape(the strips) with original screws. make offer.
I dont have the correct rack screws.

amcpsycho2
02-17-2011, 11:12 AM
Would like to have a good working windshield washer tank that doesn't leak.shipping to Wahoo,Nebraska,68066.PM me with how you want to get paid,total cost with shipping.Should fit in a Priority Mail medium flat rate box?

Coryd55
02-17-2011, 04:50 PM
Pics of clock to cadowless at knology dot net

Jeepguyp
02-17-2011, 06:58 PM
I HATE the post office, they have lost and broken parts ranging from Ring and pinions and rear view mirrors, to N.O.S. switches. If you want something small, or or off my $5.00 list, to go postal, thats fine. But be prepared to pay extra on top of flat rate or parcel post, just for me to go that route. UPS is closer to me, easier and better FOR YOU. Insured with postal service....LOL, don't bother:banghead:

Jeepguyp
02-17-2011, 08:07 PM
$5.00- $20 parts people...not NEW turn key goodies. OLD STUFF from an OLD VEHICLE. Reservoirs intact, but you need washer pumps. Clock ...Unknown, cruise stuff...???

Don't make me regret scrambling to pull this junk before it took the last ride

sld
02-19-2011, 06:40 AM
I'll pass on the cruise control until there is a complete setup.

Jeepguyp
02-25-2011, 06:38 AM
******* oops wrong thread

Jeepguyp
03-08-2011, 11:26 AM
Found the Jensen rear speaker with brackets too...think they are from a 89

Jeepguyp
03-15-2011, 11:58 AM
Bump for above and a few pieces from a 90 model.... Headlamp bezels and dash\instrument bezel...make offer:D

DARK FATHER
03-15-2011, 02:00 PM
I would want the digital clock if it works AND if it fits into my 78 J10 clock slot. The mechanical clock I have still works, but only sometimes. Any way to test it?

Jeepguyp
03-16-2011, 07:57 AM
I don't know how to test it, it has a 4-wire plug. Anyone here chime in on that?
Yes, it looks like it fits

Jeepguyp
03-16-2011, 02:59 PM
I think I can look up a schematic in a jeep tech manual......but I think if I verify the digital clock works, :rolleyes: THEN IT AIN'T ON THE $5.00 LIST ANYMORE

Heavy_Metal_Thunder_81
03-16-2011, 04:06 PM
What side markers do you have?

DARK FATHER
03-16-2011, 04:09 PM
I think I can look up a schematic in a jeep tech manual......but I think if I verify the digital clock works, :rolleyes: THEN IT AIN'T ON THE $5.00 LIST ANYMORE

The $5 price is not what concerns me, it is the SHIPPPING cost which will likely be about twice that. In the past 3 years shipping has gotten ridiculous!

Jeepguyp
03-16-2011, 08:02 PM
Pmd ya John. I'll get some pics


Darkfather... I would think UPS will bring it for $8-9 . I'd avoid the post office

710 Burner
03-17-2011, 07:30 AM
Do you still have the wrap around tail light lens? If so, how would you rate its quality? Pics?

Jeepguyp
03-17-2011, 11:59 AM
YEAH still have. i'll get some pics

grand_wag_85
03-17-2011, 06:09 PM
Hey, if you split the 360/TF727 I could use the bellhousing bolts:D

Jeepguyp
03-18-2011, 03:19 PM
here ya go

http://s488.photobucket.com/albums/rr243/Grendel45/waglens/

Jeepguyp
03-24-2011, 07:24 AM
the clock is a 5-wire... can anybody use? NO, I have not tested it

Jeepguyp
04-09-2011, 03:43 PM
Bump for spring clean-out:D

Jeepguyp
08-05-2011, 10:23 AM
I have a couple good, used flexplates, from a Tq-flite (Chrysler tranny)equipped 81 J10

Anybody want one for $5 ?
Otherwise I'm scrappin 'em when I crush a 75 Cherk

Jeepguyp
12-29-2011, 11:28 AM
Anyone want a digital clock, $5, unknown if it still keeps time:confused:

BMThiker
01-10-2012, 08:08 AM
Do you have headlamp bezels for the razor type grille? I need a passenger side bezel.

Jeepguyp
01-11-2012, 07:18 AM
No , sorry, LONG GONE.
:(
I have a pair of nice bezels off a 1990 if anyone is interested

CasualGourmet
01-11-2012, 10:44 AM
How much to 28412?

Jeepguyp
03-15-2012, 09:34 AM
2 sets of visors. Tan and off-white. one with vanity mirror