Front & Rear Driveshafts on SOA...

[The Gator]

My wagoneer is a 76 w/400 and quadtrac transfer case I am almost done w/ it I still have to get the RB kit this week but I wanna know how long do I need to extend the driveshafts or I know heimeken used a grand cherokee front shaft but he has diffrent trans transfer case setup so anyone who has done the same set-up w/trans-transfer let me know what you have done to your driveshafts... http://www.geocities.com/knippj2001/MY_76_WAGONEER.jpg

[The Gator]

.

[dnixon]

after you finish you just have to go measure and take the measurments to a shop and take them your shaft and have them put in a new longer tube or you could go find a longer one from a Junkyard and they could cut it down. Its up to you on that one.. But i don't think you will have the luck of just finding one that is going to bolt in... its all custom now.. good luck...
You will probably want a good high angled one for the front you might not have to get a new shaft for the rear but I did since i went to a shorter TC after my SOA swap...

[River Beast]

Just letme know when you're readyto order.... ;)

[The Gator]

yeah RB it will be a day or so I will let you know thanks ..Slo wag thanks for the info..

[The Gator]

btt

[River Beast]

You may be able to get away with not modifying the rear.... the front will need the high angle CV...

<<<BUT>>>

I highly recommend you install a P/T kit in the QT.... you need to.... the angle is too steep to run constantly with the full time QT....

[The Gator]

Yeah I was considering toms woods driveshafts..Thanks Wagman..

[The Gator]

btt

[River Beast]

shafts will have to me measured once you lift it.... it's the PROPER way to do for YOUR rig