driveshaft length comparisons

[Dome]

Just out of curiosity, does anybody out there know what some of the different driveshaft lengths are between FSJ's (ie between selec trac wags/cheros, quadratrac fsj's, short/longbed pickups etc).

After lifts etc. My rear driveshaft is telescoped pretty far out and I am looking to see if there are other driveshafts that are a little longer I could just bolt in.

Thanks,
Adam

[mark]

84 ford bronco front shaft with auto trans is 2 inches longer than a stock 79 chero with q track.its also much bigger in dia .direct bolt in.

[Baldy]

I got my front DS out of an 84 Wag. It was roughly 2" longer than the stock one out of my 79. Was a direct bolt in and quite a bit larger in diameter. As for the rear, I'm still looking, although it doesn't seem to be as big of an issue.

Laz

[blt2krl]

My front drive shaft's working length is 27.25in long and my rear is 44in long. This is after Rusty's six in lift and another 1.5 due to revolver shackles. So I guess it is more like 7 to 7.5 inch lift. My t-case angle was 23 degrees on the front drive shaft so I ordered a 40 degree operable CV driveshaft. I have no idea if this is even helpful knowledge but here it is.

[Lindel]

How long do you need to go, Adam. My rear shaft is about 55", as it sits in the truck. I've got a T-15/D20, which also makes my front driveshaft 20.5" long as it sits in the truck.

My driveshaft will be available, if you need it, but not sure when, at the moment.

[JeepFreak]

The Q-trac/TH400 rear shaft is roughly 5 inches longer than the shaft for the 727/229. I used one for a 208 conversion and it fit perfect.