wagoneer wood grain trim

[deereman]

Need information on how to remove the trim that goes around the wood grain decals on a 91 grand wagoneer. Also need to know where I can get new trim and decals.

[dhollo4]

If you go to "search" at top of page & enter "wood trim removal" in the general tech section there are some good posts from last Sept. on this subject, good luck.
D

[billyrb]

Removal is relatively easy. If you have rivets on yours, you need to pop out the trim-corks over them, and drill out the rivets.

If you have the kind that is held on by adhesive strips, you can use a heat gun to GENTLY warm it up, and peel back a small amount at a time.

As for replacements, we will be selling full replacement kits within the next 2 months.
www.bjsoffroad.com (http://www.bjsoffroad.com)

[joe]

At the moment I don't think there is maker for new trim. Prolly have to wait till BJ's has them avail or don't bugger up yours removing it. ;)
The woodgrain panel material is avail from a few places. One of them is Sharpline (http://www.sharpline.com/auto/featured/woodgrains.html)

[ August 06, 2003, 11:36 AM: Message edited by: -joe ]

[KaRMa]

(i had the adhesive ones and the PO had used calk under to hold it stronger) to remove mine, i just used a putty knife under the edge to get it started then just pulled it off. came clean off