Dana 60 drive shaft

[trcooperone]

I need the drive shaft side of the yoke for a dana 60. I need to build a drive shaft and I don't know where to get one?

[cmelo]

What size U joint?

[Sambo]

they make a conversion ujoint.its 1/2ton(1310) and 3/4(1350) trunions. for the love of pete i can never remember the #'s tho!

[Slick Willie]

Call some of your local driveshaft shops. I got my weld on yokes from Austin Drive Train when I built my shafts.

[trcooperone]

I have this posted on another forum and I realized I might have not given you all the info. The front Dana 44 that I am currently using is a 3/4 ton Dana 44.

Is the u-joint size on a 3/4 (8 lug) ton dana 44 the same as a Dana 60 front u-joint?

[cmelo]

I have this posted on another forum and I realized I might have not given you all the info. The front Dana 44 that I am currently using is a 3/4 ton Dana 44.

Is the u-joint size on a 3/4 (8 lug) ton dana 44 the same as a Dana 60 front u-joint?

My J20 front axle uses a 1310 Ujoint and so does my J20 rear. I don't know about other ones though.

[trcooperone]

They are chevy 3/4 ton axles right now and I am bumping up to chevy 1 tons.

If I don't the u jopint is the same that would be great!

[Elliott]

A local drive shaft shop can order the spicer parts for you.