Looking for suggestions

[Blake]

I recently built this J10.
http://blakeoffroad.com/vps/Attachments/j10_on_sand_dunes.jpg



Now I'm looking to modify the front body. I'm looking to narrow the front fenders and hood to a " V " shape. I figure if I can chop off the front of the fenders then it will be easier to see when wheeling.

Any suggestions on what to do?

[Blake]

Here is another pic.

http://blakeoffroad.com/vps/Attachments/IMG00175-20090517-1927.jpg

It's running 39.5 TSL's and could use some fender trimming, which I'm not afraid to do.

My goal is to narrow the front. I've even though about running the fenders and hood and grill from a Toyota truck....

[jeeping1974]

I've even though about running the fenders and hood and grill from a Toyota truck....

:thumbsdown: :omfg:

You ccould cut the flare of the fender off, trim the hood, cut the radiator support and use the two inner headlight holes, cut the inner fenders and make some new ones out of sheet metal after you pull the front of the outer fenders in.