View Full Version : General FSJ Tech
- Spindle bearing seal orientation
- bent axle
- Transfer case fill.
- OBA and after market manifold
- Heat isn't blowing hot?
- vacuum??
- 1978 QT problems
- how difficult is it to change a 229's chain?
- do 77 cherokee springs fit on 85 wag
- whats a good oil pressure?
- 304 rebuild tips/tricks.... Rick (Beggs,OK) you out there?
- AMC 360 vs. Mopar 360
- Source for Chrome Hub Cover?
- Noisy valve
- Steering wheel...?
- Rusty Fog Lights
- How do I mount an egg-crate grill on a GW?
- detroit ez-locker...front or rear
- another emissions question (quick fix?)
- need heater control help ASAP!
- Tail lights
- Serpentine setup sources
- Source of my problems FOUND!
- vaccuum line routing
- Setting up 88 G.W. for towing.
- add-a-leafs/new boingers
- Removing Window Trim
- best tire
- Should I put a SBC in my cherokee?
- Anybody sell replacement bearings or rebuild kit for alternators? CS130D
- leaks?
- what year did they start putting on sway bars
- Chev axles under Grand Wag
- Suggestions for 4" or 6" lift
- drum brakes
- Drive axle gears
- Can disk brakes freeze to the rotors? (Ford Exp, not Jeep)
- 3" DPA and End Links?
- Different rocker arm sizes?
- wrong breakerPoint dist?? neep pics of urs installed pls!!!
- Cross over or high steering
- Marchal Fog Lights--------Available?
- Stranded in ShowLow---HELP!!!!
- Just bought an FSJ & there's water in the oil
- 258 intake 1bbl to 2bbl ?
- Brakes went out...SCARY!
- SMOKING OUT EXHAUST PIPE, WHAT IS IT....
- 401 Camshaft question
- Filling QT
- Did I break the shifting linkage inside the tranny?
- TFI Upgrade
- Differences in 4WD question....
- Help two problems driving me MAD!!!
- which engine rebuild parts
- Cork valve cover gasket???
- T-case problem
- engine size???
- Let me make SHURE I got this right (amp bypass)
- What is this?
- POWER STEERING BOX
- How Do You Lower A Tailgate Window Without a Motor or Crank?
- rear spoilers?
- 258 Oil Pressure switch manifold
- Dome light question
- Both motor mounts broken....?????
- loose steering ?
- shackle reversal question
- Ok I messed up! I broke the carb. Can it be fixed? See pic.
- 6" lift
- Electric wIndows on a j10
- blocks or springs?
- 258 Blowing Oil
- Driveshaft question
- Where can I find these parts?
- FSJ Questions (transmission and tires)
- manual
- Electrical Issues and Bumpers!
- trans kit
- Car Cover recommendation
- Gladiator max rpm/top speed?
- Adjusting fuel pressure on pro-jection?
- What is a Cherokee Laredo?
- ? water pumps
- axle ID
- Hood interchange question
- T-5 Tranny fluid?
- motor mounts, which sides?
- will they fit?
- AHHHHHHHGHHHHHHHH!!!
- Stupid tranny
- 79 wagoneer tranny
- Back-up Light Switch Location
- Motor Mounts?
- should i change my dual exhaust to single?
- Stock Sway Bar Diameter
- Where do I need th traction most?
- Dang power windows!!
- Tranny leak
- Need quick help, what size are speakers 89 GW?
- Headers or try to fix manifold
- Wire socket for Distributor
- Super swampers
- Power locks
- Will the flywheel fit?
- ford 360?
- Electrical Problem Looking for advice
- FSJ Bone Yards in the Phoenix area?
- ideal oil pressure?
- good oil pressure=good oiling???
- No Reverse?
- AAL or not?
- new question
- help my new engine run please
- how many leafs?
- loose steering bearing
- fsj test vehicles needed for eldelbrock headers
- Bender Drawings
- M715 radiator question
- tranny to transfer case
- Need Expert Advice On Engine Rebuild!!
- Baby jeep wont start
- bolts that attach bumper to frame
- Wagon is sick... need cough medicine
- coolant leak recognized?
- Front axle questions
- how to tell the difference between a t-18 and a t-18a
- Tcase ID HELP PLZ
- Excellent Steering Column Post!
- TH400 filter change
- Rear Bumper Photo's
- axle identification???
- gauges lenses
- np208 engaging question and identification
- gear lube
- Shifting linkage loose
- amc javelin 390 into j-10?
- What's fast for AMC motors?
- Dizzy for '86 vs. '89
- exactly what clor is my interior/
- Axles worth anything?
- good replacement for a 360
- narrow track ratio question
- D300 speed chart?
- towing question
- starting problems....please advise
- base drawings
- Will they fit?
- Where to get lift parts
- Why wont it run?
- TH400 from 360 work with 401???
- fluctuating oil pressure?
- rhino conversion
- TFI Upgrade
- For anyone who has replaced cab mounts.....
- Backfire!
- NEVER balance your tires AGAIN!!!!!
- Need Q-trac vacuum diagram
- Axle id. ????
- Cheap 360 and 727
- Crazy Jeepman's guages
- oil pan gasket removal - tips?
- Wiring Diagram
- Help Chevy 427 question (in a FSJ)
- Chevy drivetrain in Cherokee, got some questoins...
- Fuel Sending Unit
- rebuild with QT to select track switch?
- Intake install question
- Where do I go from here?
- Bearing inspection
- Alternator Problem
- cutting off the top
- AM RACING
- great site for trailer wiring info
- Pre 77 fuel tank ?
- Best service manual for 89 G/W ?
- 4 wheel drive will not engage. help!
- Ford Dana 60HP
- Door Panels
- Idle Speed Questions - 360/2150
- Does a d-20 have to have a gasket?
- rearch or new springs?
- Help me lift my 86?
- Oil puddle @ distributor base
- Woodgrain Repair
- Stumbles/hesitates during acceleration...
- Heres a good one
- Good place to go for carb. ajustment information
- TFI Upgrade
- Jacobs Omni-Pak
- engine won't start every thing is dead
- testing an egr valve??
- wiring an 82 258 into a 74 wiring harness?
- dash board is out! help!
- 81 Cherokee Gas Tank Question
- HEATER BLOWER
- aux lites relay
- HUB SWAP
- stalling
- hood-mounted spare tire?
- dash question
- emrg drive?
- front end suspension
- Vented VS. Non-Vented?
- Gas Gauge read 3/4 when full....
- anybody running the 71,72,or 73 TH400?
- adjusting shiftpoints TF727
- Locker Installation
- Cam question
- stalls when turning
- Vacuum lines, charcoal cannister, and other such stuff...
- Front axle ?
- Valve body in TH400
- Houstin, We have a problem, oil pressure dropped to 0 at 55 mph.
- How much for a 304 rebuild?
- just a thought
- Carb rebuild/replacement
- dana60/dana44
- Lift question
- which exhaust system should i get for my gwag
- your favorite 727 rebuilt kit and tool advice
- Shakes
- Compatibility charts?
- BBD/motorcraft carb swap Q's
- TIRE WIDTH
- Drivers door Droop
- traction-lok
- Anyone use the Ford one-piece spindle locking nut?
- OVERHEAD CONSOLE
- POINTS
- Rear seal
- brake line flor snow plow?
- Dana 20 electrical connectors
- Brake lights always on
- QT indexing ring
- ignorant brake bleeding question
- Model 17 NT cherokee S ?
- Front seat
- More Peso woes/Fellas help
- Superlift System
- Fluid Leak, Yikes!
- Sticking throtle
- "Performance" Muffler for a 258
- Driving, Driving, no electricity.
- part-time QT question
- top speed 45
- Brakes randomly locked today, thrice!
- Weather related Oil Leak
- Gas Gauge
- Question
- whistle when deaccelerating
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.