View Full Version : General FSJ Tech
- Ok, I'm keeping the 360 questions about the build up
- disc brakes
- Need help starting 88 GW that's been sitting 2-3 yrs?
- questions on tires
- 6.2 diesel NV4500 which bellhousing?
- The nightmare of wiring. (rant)
- Tune-up time...
- Good Idea or Bad?????
- Roll Cages Revived-Help NC guys
- Good deal or keep Woody
- stuck spindle
- Will '83 seat base fit '88 GW?
- e - drive
- NP229 to Manual 4WD Shift
- Help - Emissions failed.
- 4.3 chev vortec
- How much torque...
- Someone help me before my head explodes.......
- 73 J4000 Gas tank sender unit part number!?!?
- good deal on FSJ? not dial-up friendly!
- grille and hood swap
- It Failed
- Cal smog test horrors
- gsmikie......bushing replacement questions
- Quick Check..New Carb Price
- OK what Ign. system do I have?
- 10 bolt flat tops knuckles fit d44?
- heater core replacement - two questions
- when removing the air cond pump...
- HELP, MY ENGINE WONT CUT OFF
- help oil drain plug
- arg! Harmonic Balancer doesn't want to come off!
- HELP! Steering Column caught on fire!!(pics added)
- Clutch linkage question and idea
- steering column swaps?
- Driveshaft.
- looking for wagoneer color codes
- spare tire rack for 35" tires
- J20 Spring perch to perch center measurements.
- What the heck is going on? Smoke from the carb?
- part-time qt?
- "Dauntless" 350 or 401?
- Fuel tank return, who needs it??
- more electrical problems
- HEAT-DEFROST Switch Question-FIXED!!!!
- HELP - No Oil Slinger when I took the front of the motor off. Am I 'missing' someth'
- avatar ???
- tow package a/b option ?
- 401 Valve seals?????
- 401 intake gasket woes.....
- HOW MUCH LIFT?
- Can I extend a tap? no room for the handle!
- Replacing input seal for my quadratrac?
- 401 to 258, What's it take?
- wagon seats in a J20?
- electrical problem making squilling noise
- Cracked Harmonic Balancer
- water kills the beast...any solutions ?
- to bench seat or not to bench seat
- Did I mess up steering box by adjusting to much?
- Any idea on horsepower of 360 with our common mods?
- Twin Stick shifter boot?
- flexplate ???
- oil prime problem?
- thanks
- Quadratrac reduction unit????
- Twin Stick D20
- Tail lights
- Need Light Switch Expert! No dash lights!
- 360 V8 Stripping Distributor drive gear!!!
- major arching problem
- major arching problem
- 12v coil wire to tfi???
- I bought a set of Firestone and they seperated!
- 360 vs 401
- Robert Shaw Thermostat?
- transmission question
- Tornado to Vigilante swap?
- 86 GW A/C
- the timing cover
- cheapest high flow water pump
- got holes in the roof of GW
- rear slider window
- 360 ???
- need this diode assy
- windshield wiper delay
- Carb rebuild kits
- Another dumb question?
- Part number for the heater core
- odd occurance
- radiators?????
- cast iron welding
- Cast 258 valve cover source
- Wiper switch or wiper motor??
- Any idea where these carb hoses should go?
- u-joints
- 4" vs 6"
- Rebuild 727 if I'm going to change to a Chevy Motor?
- Problem found, bent tie rod.
- motor mounts
- EFI for 401
- Done with new timing Chain. Truck wont start! Help!
- cheap replacement carb
- Vibration in $WD
- THIS is IT !!!
- WHAT BRAND OF LIFT?
- main bearing qs
- catalytic converter only???
- Key turns too far to start.
- RUSTED GAS TANK
- WINDOW REGULATOR QUESTION
- keep it or sell ?
- Edelbrock heads, dual quench??
- Serpentine belt
- Wide track vrs j10 axle width
- whats the problem?
- gears, l/ & lift
- New noise any ideas?
- BDH 79 WT T18/TC into a 77 TH400/QT?
- Emissions, to test or not to test...
- Replacing rusted Wagoneer rockers
- Replacement Body Mounts
- rocker protection
- Hey Tadsal
- Tightening GW Steering box adjuster.
- bumper mount/frame dimensions
- Headlight switch removal on new style dash?
- Welding Q
- Edelbrock Intake manifold
- lifts & gears ???
- no power!
- bleeding brakes and M/C
- looking for turbine style rims 15x 10
- Need some help with a measurement
- wiper fluid container
- How do I pull the dashboard?
- 89 GW springs fit 84?
- radio size 1 "dinn" ?
- Cheap rear window switch for 84 ish waggys
- lots of drivetrain swap questions...
- power steering pump replacement tip
- BDH 79 WT axles in 77 NT
- Rear Window Channel Replacement???????
- Update on Pep Boy engine problems
- need tips on sealing tranny pan
- Puke tank, Cap etc for FSJ Cherokee
- ? For BJ's Offroad ? ? ? ?
- 25% off parts
- Carb problems on 83/6 cyl
- How to really bleed a new brake setup
- STRANDED
- AC question
- front drive shaft
- start up after sitting
- Where did you get your lift?
- new rear window switch wont work.
- What CB radio?
- rust holes in floor board
- River Beast (front D-shaft Q)
- What is a direct replacement for 2150 carb
- about part time conversion...
- WT axles - are they worth it?
- '82 grill for a '65
- AMC 20 service articles and illustrations.
- wiper motor
- all years have same antenna?
- who makes the best kit?
- Tailgate glass channels inside gate, can you get them?
- Motorcraft 2150 tuning questions
- 1975 J truck questions
- Sad Day - The J Truck ain't gonna make it.
- PVC and Gasoline - Compatible?
- Gas Tank for J10
- Paint Question and a few others
- sound of a loose flexplate?
- 88wag ac condenser price /availability?
- Can a misadjusted choke do these things?
- exhaust leak w/pictures...
- another grill question
- is this a j3000 or j4000?
- 79 chief with no power? Help please.
- Oil leaking from everywhere-help!
- anyone know about FC's?
- Rebuild, myself vs shop$$$ 401
- j2000, j4000 parts
- j-truck keeps popping out of park
- Quick TFI q????
- 16" early 70's J-truck wheels/5 lug
- gas guage doesn't work...
- brake lights not working
- HELP New engine installed but wont turn
- Body off restorations? yes or no?
- Where to find?
- mods for 258
- tryn to ID. gears
- Dual exhaust question
- torque converters
- Bigtime exhaust leak! Which headers?
- Exhaust Manifold bolts - Stainless ok?
- Part time kit for QT
- 401 WHAT YEAR?
- CJ vs FSJ AMC 20s
- Limited slip Differential?
- Ham Radio in 87 GW
- NP transfer case 200 series input bolt pattern
- I need info on this winch. Pease help!
- 727 weight
- Go%%@mn Yankee Peugeot!
- Anybody used one of these crank scrappers?
- Replacing Rear springs, what else to do....
- Parts Availability and more?
- what size in gallons is the tank
- did the threads but broke the coolent intake!
- Eng. vin location ???
- What to replace 4350 with??
- VIN Change 91 to pre 77? How Much Swap Nec
- Followed Dodge "Heavy Duty" what is the rear axle in this?
- rear mounts for front springs R.I.P.ped!
- Are the FSJ steering boxes all the same?
- intake manifold problem
- head liner
- How do you hook up towing lights?
- Vote for your favorite starter
- Loose Tilt Wheel.
- Transmission cooling line rusted out
- Transmission ticking
- Couple of newbie engine timing and vacuum questions
- Couple of newbie engine timing and vacuum questions
- Motorcraft 2150 strange flooding issues.
- BDH 79 WT D20/T18 into a 75-77 WT QT
- some sort of clanking sound with the brakes?
- carb linkage problem, need your help (ADJUSTMENT TO POST I WAS WRONG)
- saddlebox/tonneau cover???????
- Control Module?
- nifty photochop...
- power window - door panel removal?
- slow, steady progress on my engine transplant
- NP 208
- Can I rebuild my 700r4 myself?
- Do ya think these headers will work?
- aftermarket ignition and coil
- Is Buick 350 An Easy Swap?
- 401 crank in a 360??
- I may have nicked my crankshaft (RMS questions)
- 360 gas to 350 Diesel - What's it take?
- Intake manifold stuck on
- rotor and caliper q's
- Flexplate questions
- What transmission do I have...
- Tranny or Transfer Case Bad???-long
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.