View Full Version : General FSJ Tech
- holley truck avenger
- New exhaust! Majorly happy with my new muffler!
- Front Seal Replacment w/ TC still on Truck?
- roll-over gage
- fuel tank skid plate
- cruise control over 65mph
- Who's done a lincoln locker.
- which cam?
- parts 76 Wagoneer to 85 Wagoneer
- Why won't my caliper compress?
- Why is this hole in my transfer case?
- E-brake cables = suspension limiting straps
- E-Brake cable
- Dana 44 Knuckle Removal
- Best way to wire h/o alternator
- SPARKS FLEW EVERYWHERE, AND THEN. . . .
- bad cam?
- How many miles are they good for?
- trailer tow relay
- Jeeps have a mind of their own.
- Engine Gasket Set
- Vinyl Roof Removal
- can you run 15x10 rims with 31x10.5 on a stock wagoneer
- Keep AMC20 LSD or replace with???
- help crank question
- mystery noise
- Front diff
- '72 j2000 differential
- Engine replacement wrap up
- To Roller...or NOT to Roller..that is the ......
- toasted wire
- stock carb tuning?
- Off-Road Needles and Seats for Edelbrock
- TIRE SIZES/ 3" SUSP LIFT
- is it legal?
- sound kosher?
- Pics of Waggy SOA?
- New Shocks
- Engine R & R write up
- body bolt torque
- inspection fun
- Help with carb linkage?
- Now I have no Exhaust, how far can I go without burning a valve?
- manual hubs
- rear air deflector
- Disadvantages to a longer front shackle?
- dome light removal
- Interesting TH-400 case info
- Aluminum Bumpers
- Whats the best way to plug exhaust ports?
- How silly will a nt front axle look on my j truck?
- divorced BW1339
- Which head is best?
- Power Valve?
- which converter to use
- What Axle combo(s)/t-case in a J4000
- TFI Upgrade
- not charging until engine is revved
- acc. pump position (linkage)
- 4 Barrel 360
- 83 G/W. Best place to buy FlowKooler Water Pump?
- Hood clearance
- Project Update and Questions
- How do you diagnose charging system trouble?
- lift install q
- Factory re-built short block
- np229
- OT: 72 Olds
- Headers for GW w/360
- Info on diffs
- does an NP209 have a viscous clutch
- One way valves...what alternatives?
- Replaced starter solenoid..problem is maybe gone.
- Where to find recall info on any auto?
- Help! GW Oil Sending Unit
- is a valley pan necessary?
- wandering cherokee............
- Swiped buddies NEW Holley 750,now how to adjust?
- How long to install motor mounts?
- 83 G/W Where do i find Spec. information?
- 83 G/W Where do you go for crash shields?
- 258 to 360 swap
- BLACK GOOP IN REAR AXLE
- FSJ sheetmetal... What gauge?
- Looking for a crate 258
- Would two flowmasters be quieter than one?
- leak at the shifter seal
- Headliner Woes
- new ehaust suggestions??
- Electric Cooling Fan Question
- Fuel Cell Fittings
- Another charging system question
- Surges going downhill, but no other time
- running warmer on highway
- Opions on Oxy/acetelene tank sizes
- High pitched scream
- Can I get H/D U-Joints for my 78 cherokee Q-Trac?
- Ignition Upgrades - TFI/Jacobs
- Dana housing spreader from Randy's R&P.
- low range shift shaft leaking, please help
- "older car" products?
- D44 Crossover Steering
- engine swap
- engine help--what's this hose?
- Will springs from 77 fit an 83??
- gas tanks
- How does this purge canister work?
- EGR transducer help needed
- Fuel milage experiment results.
- help! transfer case bled to death...
- Rear Power Window Problem
- some man truck questions
- Transfer Case Stuck?
- Offenhauser Equa-Flow manifold?
- TFI guys....HELP!
- Fan clutch worn out?
- Does a rebuilt engine take some time to get the power back?
- Do Timing Chains Stretch......
- CAT HELP!
- Where to get some factory type rocker arms?
- tailgate window crank
- Waggy question
- 7.3L diesel?
- Hell Creek Lifts?
- hey body guys,should I wax or glaze it?
- What does antifreeze do in oil?
- The most important thing I have learned in the last 12 months.
- 360/727/300 in a CJ?
- 360/727/208 t-case location
- EGR first used when?
- header clearance
- Amyone know where the interior (unddr the dash) grounds are?
- Expert 2150 Carb help needed!
- 360 oil filter adapter....which way does the washer go?
- Dana/spicer 20 case linkage problems
- 258 carb
- axel ?
- original thermostat--is it possible?
- Charcoal Canister
- could someone walk me through fan clutch installation
- Think I Found My Knock. Comp. Test
- Rather long post on Alternator Theory...some background
- Pinion yoke torc?
- 83 G/W Lift Questions - Help
- Post and Box Mounts
- 85 grand wagoneer random stalling
- Sparks while jump starting?!?
- Anyone have this problem?
- screws for center caps stripped
- power locks not working entirely
- Who was looking for info on the oil mod?
- SOA
- Throttle solenoid -- some questions
- 1972 J-2000
- Is tranny hooked up to the radiator?
- Paint Opinions Wanted
- mc2100 to 258
- revolver shackles?
- How much oil pressure is too much?
- Ignition Modules & Engine Wiring
- Whew! Lots of stuff FUBAR'd
- axle id?
- Dana 300 driveshaft? (Scotty)
- 360 Wants a Nice Home
- body lift for a manual transmission
- 4bbl conversion (mr gasket adapter)
- 727 Overhaul
- Best grade/brand of radiator hoses?
- brake help once again
- Hi slips in to (N)eutral while driving
- Rebuild nightmare, What the heil is this?
- rusted spring perch
- If you sell, will the new guy call you a DSPO?
- change needed?
- MECH. FUEL VS. ELEC. PUMP
- the problem with the man truck
- Disappearing brakes- J4000
- I need opinions and advise!!!!
- 83 Wagoneer Lift ?
- I think I figured it out, but have several questions?
- winch mounting
- Should I have compression with collapsed lifters?
- Can I reuse valley pan if it's like new?
- TH400 pump question
- Buick 350 fuel pump question
- Fiberglass or Steel?
- What gear ratio in '82 with NP208
- 327 rocker arm bolts
- Trannie ?
- Axle Questions fro my 76 and best place to get gears
- T-Case Linkage?
- If i have an oil blockage, how can I remove it?
- Quadratrac
- wago tailgate glass
- CTO switch identification
- 258 Motor Mounts
- GW Doors don't shut
- Amc th400 and gm th400, whats the diff???
- Pacer Bucket Seats
- MPI, TPI, whats the diff?
- Quality Gears
- Stainless Rocker covers
- Tellico I think is out! And my rebuild is screwed. Heres a list of casualties
- New timing chain slop
- Dead spot on rear window motor?
- Sorry about the stupid first question, now who sells the timing cover the cheapest?
- Question 'bout ESPO lifted springs
- Dimensions for a TH400
- rare rear floor access panel?
- 258 Header
- Some one link me or tell me exactally how to install new stuff!!!!!!
- If I am getting the wrong parts, how to tell?
- Any special mods for Rusty's 6" lift
- Grille Swap
- Sorry, another valley pan question
- So how can I tell if a lifter is properly primed
- Should I change just timing chain???
- Can someone do a n explenation engine terms?
- These are the rockers Summit says will work?
- So all these parts should work together?
- '72 Jeep Shop Manual Online (in .pdf format)
- I need some opinios on what I should do now?
- Replacing u-joint straps with u-bolts
- 83 Wagon Ltd. Where is the best place to find some missing interior switches , etc.?
- Fuel Delivery Problems!!! UPDATE. FIXED THE PROBLEM
- Some one please explain lifter preload, and how to check?
- Idle Adjustment?
- 1966 amc 327 parts wanted
- Starter problem 82 Cherokee WT
- Pulled oil pump apart, heres what I found
- Best easy install locking device for AMC 20.
- Another one: Stupid Lift Question
- ARB Bull Bar
- What is normal for the first start of the day...
- Transmission troubles
- 258 Starter Problem
- Not only are the cam and lifters a problem
- Dana 44 perches
- Anyone have a rebuilt 401 they would part with?
- One other possible reason for my troubles
- To KYJ10
- Do MileMarker still make 1:1 Part time kits??
- Aftermarket SPEEDO hookup ?
- Would it be wise to change from clutch to flex fan?
- Hand Crank for Rear GW Window Question
- trailer wiring T adaptor
- Pic help, J10 with ABR Bull Bar
- How bout putting a 5 speed behind a 360 Wag
- Newbie Question
- Replacement Dash
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.