View Full Version : General FSJ Tech
- Raiders of the Lost Junkyard
- Intake manifold question
- Timing Questions
- tailgate motor specs
- EGR connections to Holley carb, how to??
- EVER HEARD OF FACTORY CB?
- ok using 304
- Body Interchangability
- How hard zit to replace intake manny?
- t/case questions / suggestions
- breaks o fading
- Carb problems
- Gear indicator on steering column...how to fix??
- Wheels
- part numbers for calipers?
- Precision Gear vs Reider racing?
- Yikes! Did some carb/vac work, now engine runs good but won't drive!
- Irradic Oil Pressure
- Keyless entry...easiest system to install.
- Trany blowing oil
- OK,,,How do I clean out the gas tank ?????
- OT-New VW Beetle, Help a guy out!
- Carb problems
- lug patterns
- do you need a case splitter to do gears on the front dana 44?
- fuel system pressure
- How Much Can a FSJ Safely Tow??
- dodge to jeep swaps for 2003
- Overdrive in 89 Grand
- charging problems
- Axle configurations
- BATTERY
- FSJeeper! dodge np435 questions
- How in the heck do you put the harmonic balancer on?
- i warned you guys that im new......
- buying a used engine
- Manual hubs on a GW
- M-715 trans gear ratios?
- unreliable ignition
- Body Swapping
- BW Quadratrac chain
- How do you make a gm hei fit amc?
- I really hate to post these things here....
- Axle question....?
- right rear passenger electric seems bad...
- Tailgate Window Motors
- Engine Quits Running!!
- Hate pumping gas
- 327 experts - oil pickup differences?
- 14 bolt shaved, disk converted, now rim time. Help me out!
- Headers for a j-20 401 V8
- new seats
- the new springs are here! the new springs are here!
- Spring Compatability??
- Ran out of gas... again
- 4" lift with rear AAL
- Power Steering Fluid
- Motor crap 4300 (Don S)
- how far does the harmonic balancer go on?
- Exhaust sytem
- Header Questions
- Smog Fix Suggestions Needed
- Replacing brake lines?
- Ballast Resistor
- Starter motor heat shield
- Anyone Using Eagle Alloy Wheels?
- edelbrock performer package
- Tranny problems - no gears
- Burning, stinking plastic smell = light switch
- Vent question
- Ford ignition Mods
- 258 6cyl coolant routing question
- Heads out, now what??
- Anyone done HEI upgrade on their 258?
- Home Built Title Questions
- tuned up, now idles rough, TFI questions ??'s
- cooling fan direction
- heater sucks a fat one, help!!!
- removing leafs for better flex?
- Stereo's too flashy!!!
- Springs from other makes
- Which Lift: Rough Country / ESPO or Rusty's
- 14 bolt going in, hows this sound?
- fuel sending unit removal
- Another Chevy spring question
- another tire,lift,wheel size question.
- DSPO of the Decade
- th700r4 to d20?
- how much does a 360 weigh?
- preping for paint
- anyone having problems getting on pirate4x4?
- Whats my best setup for the drive shaft U-joint when doing the 14 bolt swap?
- HP @ max RPM,s for 258 6-cylinder
- I failed in NJ!
- power steering hoses
- HB Questions
- Anyone run different backspacing from front to rear?
- Stalling problem
- MSD Ignition Box Install??
- Rhino Grill - Tranny Cooler placement
- fuel pump
- Rusty's lift ?
- EGR valve for '90
- Catalytic Converter
- To paint, or not to paint???
- newbie quick question
- I Think My Cherokee Is Jealous
- fuel filler/e drive help
- 2150 high alt carb
- fuel sending unit upgrade
- Poor performance from broke air pump line?
- lifting
- Lift without rubbing??
- t-5 behhousing
- Closed nuckle to open nuckle
- 1970 360 vs. 1978 360
- Crankshaft Bolt
- Dana 60 6bolt hub conversion?
- Caster angle and CV-ujoints?
- steering box mount fab help
- Auto hubs to manual
- Exhaustive comparison
- Overdrive Options??
- How To Seat The Torque Converter?
- Exterior trim removal question
- 80axles
- backfires
- J10 Gas Tank
- 14 bolt torque specs?
- Edel 1405
- I know it' winter and all............
- Power windows
- help with identifying this vin#
- gas tank size
- Automatic to manual tranny swap
- HELP TRANNY PROBLEMS
- rocker panels
- WELDING IN SHEETMETAL
- ford motorcraft carb
- crawltech?
- start up
- Checking In
- magnetic pickup
- Cold vs. Std. vs. Hotter plugs
- Fuel tank for '78 Cherokee
- 360 Damper question
- Dual Alternators......... on a AMC V8????
- Windshield polishing
- Is the 232 block the same as a 258 block?
- Automatic to 4speed swap??????
- Window conversion
- How much gear oil does 14 bolt take? And what is the red stuff?
- testing
- trimming crossmembers
- Skyjacker vs. Rusty's
- Update on $1 J20, and wheel size confusion.
- Magnetic drain plugs???
- Compatability between J3000 and J10-30 Series
- A little help with gears...
- Open Air Cleaner
- installing CD player Update!
- QT nob in glove box. How to remove?
- Driver's side vent wing window knob loose.
- BDS springs any good? (BDS vs Skyjacker)
- Flexplate?
- Timing Problems in Tampa
- I got the shakes
- difference in a 304 & 360 flexplate
- '75 J10/20 in bed aux tank
- dana 60 6 lug
- dual exhaust
- Help with water pump mishap!
- Fuse panel help/ID?
- What tubing tools do I need?
- Exhaust Leak?
- Fuel Injected AMC 360
- How to set the timing- TFI
- Looking for M715 Bumper specs.
- 428 Rear End
- very rough ride
- What gears????
- Early model brake upgrades?
- Home made Quick Disconnects???
- stock rims and tires
- Winter sucks, let's do some jeep fixin'
- Alternator question
- Pros and cons of poly fuel tank
- Weird problem...only driver's door opens from inside
- Bumpers, brackets, pre '80 vs. post '80
- Alt gauge needle going into the red...
- 80 PSI !!!!!! blew oil filter seal ????? AND yes you can do 50mph in 4LO
- vacuum at idle
- Need new front & rear bumpers. Where to buy?
- newvbie FSJ
- Jeep Fixed Itself Again
- How can I tell WT or NT
- Electric choke
- delay wipers (a non avatar post)
- New to the FSJ relatives.
- Fog Light Relay
- Where to find NV4500s?
- new coil connector
- 2150 information, if anyone is interested
- anyone running a dana 300 on their FSJ?
- Vacuum lines on Edelbrock
- emissions info, will it help?
- Another 1406 question - fuel filter
- Fuel Tank
- Anybody have J-shift D20 diagram?
- Steering question
- 360 crank endplay
- Back up light question
- No Spark!!!
- Do I need longer brake lines with Rustys 4" kit?
- Drum Brake Cover - Manually release shoes?
- Pilot bushing, how far does it go in?
- hood hinges?
- parts for 86 wagoneer
- Dana 44 Power-Loc
- Dangling plug near my TH400, does anyone know where it goes?
- Broken hub???
- 2150 on edelbrock manifold
- Stalls and starts hard
- Got My Stock Wheels Chromed
- do I need to sleeve this engine?
- My Red Wagon now has the heart of a Ford!
- Trailblazer Fuel Tanks
- power steering
- Dual tank filler cap location - opinions needed (pics)
- Manifold bolts
- new stock springs?
- Brake beef up
- Had a Close one today
- New in Tranny cooler
- Help... I broke my Jeep!
- what is the difference?
- Locking Gas Cap?
- 4350 carb info
- Body Mount Questions?
- Need a P/S Pump/waterpump/timing cover stud
- pushrod question..
- what will cause stumbling leaving my inclined driveway?
- What are the symptoms of a shot timing chain?
- Tranny differences? Pre'74 vs post '74
- Another carb/intake question
- T18/D20 tranny mount ?
- I dun broked it good!! (transfer case)
- Edelbrock Carb
- wood bed side rails
- Adhesive
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.