View Full Version : General FSJ Tech
- egr valve
- Where to find match paint... grrrrrrr!
- Gas Tank
- 4 inch rustys spring mods to fit '74 and earlier?
- 258 cuts out while driving (freeway speeds)
- 401 Engine Donors
- SOA question...
- pre '78 ignition upgrades?
- Off set Tranny MOunt??
- eaton 2 speed axles
- dipstick tube broke!!!!!
- Jeep... taken to the end...
- I need some NP228 questions answered quick!
- Tranny Woes.. Woe is me.
- Engine,tranny,axles specs?
- Dual or single exhaust for my 360 swap?
- Quadrajet question
- Tranny Mount
- what axle do I have? 81 Wagoneer
- Plow's that fit
- Carb problem??
- How can I check the voltage at the spark plugs?
- NP208 VS Dana 20/300, a professional opinion.
- Another trans problem!!
- 258 HEI Upgrade
- New Spring Bushings??
- Transfer case???
- won't start in the mornings.
- Rear window motor question?
- Welded motor mount bracket question
- Rear axle seal
- 86 GW TFI Conversion
- Disc-o brake kit
- Draglink Question
- NON FSJ question
- Ignition Control Module blues
- 85 GW Instrument Cluster Clarification
- Anybody got the TFI Wiring diagram
- right pull
- Some 360 questions?
- Taylor plug wire P/N ?
- How Much U-Joint Play is Acceptable??
- ARGH!!!! E-brake cable won't come out
- Who shoudld I buy a radiator from? and which one?
- Harmonic balencer?
- stoopid exhaust manifold plugs
- Need Help With Rods, Please!
- J10 Tailgate Latch Help
- High angle drive shafts
- grand wag woodgrain trim removal and instalation
- Rebuild kit, Who to buy from?
- Fuel Return Line
- Fuel Return Line
- four piston calipers and vented disc brakes
- rancho 9000 shocks
- Long/Short block?
- please, set me straight.
- Steering Shock
- tranny sifts wierd
- Where to get replacement mirrors?
- Has anyone tried to lower their TC?
- Technical Difference between 229 and 1339
- My Jeep is Fixed (almost)
- Stuck nut
- fire in engine compartment, I need help..it won't start!
- WHY?
- body lift for a pre-74 Cherokee?
- Chrome trim, how to put it on?
- Okay Do I need a New Module to put TFI on a 76
- Shift Kit/Transpak For 727???
- Best tool??
- update 88 grand wagoneer (dif. / transfer case)
- Need info on cleaning the cooling system on engines that have sat un-used
- loking hubs
- GRAY SMOKE?
- Finding Parts For My 72 J4000
- Steering linkage for Chevy SOA???
- plug wires for TIF conversion
- 73 engine into an 83
- Grinding the front diff...
- 4.0 head on 4.2
- tuning the carter 2bbl carb
- Dana ratio tags
- Anybody running a NON CV front drive shaft?...or I got the driveshaft blues....
- Where to buy the GMB High Perf. Water Pump
- I need advice on removing A/C unit
- draining torque converter
- "an exhaust system can also be too efficient."
- Is steering stabilizer only helpful off-road?
- anyone know these casting numbers?....
- Blowing Powervalves
- OIL LEAK.
- need Rusty's install help....long
- A/C system
- Getting ready to drop the 360 in and need an answer please. Which holes?
- Which V-8 dist.???
- Headlights
- PCV /Brake booster ?
- qtrac maint.
- NP229 ?
- headers
- SOA and the DPA???
- Let me ask the question a different way, what leads to low voltage at the plugs?
- rims
- p w tailgate
- Rear shackle flip....
- Power Steering leak
- Oil pressure sending unit
- could it be the carb?
- New motor or not?
- rear tailgate window
- AAL With Lift Springs....
- Do you have any of these?
- After shortening driveshaft, do I have to rebalance?
- TFI Parts help
- agr gear box
- Quadra-trac or 208
- Are these motors any good?
- Rotor removal
- Engine start nightmare
- How thick a mount shood i build???
- 4.6L Stroker
- U-Joint Replacement in the Morning
- Cam walk
- Ping, Ping, Ping and more PING!!
- dash swap
- Glove Box Replacement?
- Some one with a 360, please tell me which way fuel lines go?
- Where can I get the right high pressure steering line?
- 360 up to a 401?
- Things to do for trailering???
- How do I use this Multi-Meter?
- 9.6V or 12V to the TFI Coil?
- aarghhh
- newbie 81 Wagoneer t/c question
- brake problems
- SOA question???
- Running Lights...
- Gas Tank Filler Ring
- Carb Question
- help !!!!!!!!! 1996 grand cherokee rear seal
- Black vs. White Rims! :o
- driveline ?
- Where to buy brake parts for a 67?
- 1979 CHEROKEE
- Clock wiring
- Tires
- Tailgate motor
- Rear Axle '66 J-Series
- lifter problems
- Front Wheel Bearings
- electric window
- Idle problem
- Fan shroud for '74?
- conversion for low range?
- Exterior dimensions: 343, 360, 401
- exhaust manifolds
- e-drive
- Water pump questions-'88 GW
- One malfunctioning guage too many!
- I need a transmition brace
- Another possible carb question?
- Do I really NEED the lift?
- poly gas tank
- Edelbrock 1400 carb Driveability?
- Yet another rhino question
- Photos
- Bad gauges
- WT & NT bumper difference?
- Newbie Question...
- Oil pump
- Quick Tranny Question
- coil suspension
- Quarter Panel Question
- Motor Swap Question
- Stuck transfer case lever??
- Lousy throttle response
- vaccum hose routing
- fuel sending unit
- ChryCo 360 vs. AMC 360?
- Vibration
- Torque Converter or Roller Rockers?
- FYI: Boneyard '79 , Barstow CA
- Studdering
- X-CASE Questions
- a/c compressor source
- Rear Dana 44 Pinion Question (RB: Please Read!)
- Water wetter and Thermostat
- Greasable Shackles for an '86 Waggy?
- Fuel pump question...
- Fuel pump question...
- Need help with defrost/tailgate window
- Anyone here have the Truck Avenger carb?
- Radiator Pukes After Shutdown
- Do I need to prime fuel pump?
- Strange Noise at Off Idle
- Wierd start up vibe....
- Changing grilles...
- Which carb?
- Starting an engine that has been sitting: need suggestions
- ATTN D44 DIFF GURUS!
- Best way to seal valve covers?
- front spring lift questions
- Rebuilt motor source???
- GAS IN THE OIL SINCE I BOUGHT HER?
- Backspacing on wheels to 35x12.5 to clear springs
- Ignition module wire functions
- lights dimming?
- 87 wag drivers window problem.
- Dome Light
- Easy ?
- fuel filter?
- Recommendation needed for HVLP rig and paint...
- Are rocker arms and bridges still available?
- What color should I paint the frame and axles?
- Has anyone built there own sandblasting cabinet?
- Installing pointer in shift quadrant help
- Seat recommendation needed, Geo, Accord, Volkswagon?
- CJ, how's the "frame off" project?
- xj question-disco axleshaft bushing
- Squeeling alternator belts
- Is this a Good Long Block 360?
- 4l80e manual valve body... someone's making it
- Switching to 350. Whats involved.
- clutch problems
- Time to replace water pump??
- all kinds of racket up top!
- Anyone Hear of S&S Machine in Spokane?
- Voltage dropping at higher RPM's
- Any good books about rebuilding a 360?
- Vaccum Advance
- 64 Pickup: how to tell what model?
- spring length?
- VIN frame location
- Manifold install question
- 4.0 head swap questions
- Double CVJ on Front Driveshaft
- Car Trailer/Dolly Plans?
- Need axle ratio ID help...
- Choke....Egr....Tune up questions?
- What type fluid?
- Gettin rid of the gas smell. Change plastic tank?
- transmission (turbo 350) question
- I need a dipstick....Where? length?
- Where is the voltage regulator??
- Upper Ball Joint Seat Tool
- Driveline Woes
- Alternator Swap
- never assume nothin'
- chevy 350 engine swap?
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.