View Full Version : General FSJ Tech
- Compressed air tank help
- motor swap ?
- TH 400 bushing causing issues on motor install...need help
- weird engine question
- Wagoneer buildup...slowly
- Breather fitting for a 78 WT Dana 44 front end?
- motor won't stay running
- Oil Cooler Question
- Grand wagoneer cracked transfer case.
- d44 hub removal help! Help a new guy!
- bellhousing bolts?
- High cold oil pressure
- OK, got a question, might be a dumb one...
- replacing heater core only and/or assembly on firewall
- Re upholstery
- Brake Failure!
- 1 more quick question
- At wits end with this brake issue!!!!!
- Edelbrock carb vacuum port question.
- Turn signal switch replacement
- Putting 360 back into J10 - what can you add beforehand?
- replacing floors - POR-15 and undercoating?
- Pinion nut
- Dumb quick question about Truck Avenger
- Replacing rear window trim
- Testing Alternator and Battery
- Crankshaft bearings; need some suggestions
- My 74 j10 project
- 4x4 problem...
- CCCCCOLD. Heater issues...
- NP 205 question
- Noisy T18
- Axle swap
- How do I remove the cowl vent cover
- Rust - floor pan replacement (cost)
- motorcraft 4300 interchange?
- Alternator Question and Revelation
- OK what would you do? Leaker!
- 401 Swap into an 81 J20
- Emergency, no lights at all
- New Headliners?
- any RTV or sealant on O-ring for fuel sending unit?
- 4 barrel carburetor on the ol'360
- Steering Stabilizer
- Key/ignition problems
- Seat Slider Removal?
- Body transplant to a K5 frame...
- 1978 J10 401
- Dually Conversion???
- quadtra trac question
- jeep swap
- Running good with new problems
- Installing a new temp gauge
- which fuel pressure regulator
- Transmission "clunk"..?
- Buick Radiator Fitment
- "command trac"....."selec-trac"....???
- NP219?
- DANA 20 PROS, I could use some input..
- Winch on 3 piece bumper
- Electrical Q 90Volt DC???
- what carb
- Backspacing...
- Cold start issue Michigan
- rear gate glass question
- MC2100 carb problem!
- AMC 360 swap
- MC2100 Problems
- So I got my Waggy running last week
- vent window repair
- New meaning to sludge
- Pic Request - Hood Latch for Razor Grille
- 1350 VS 1310 yoke
- Emergency Drive Question
- Clutch replacment
- Modulator valves and hose thingies...
- Cherokee Workshop Manual
- Diesel Donors
- Seat for a J10.
- Vacuum Lines
- 727 trans shifting problems - SOLVED!!!
- I have some issues with my 727
- Hesitation Mystery - Part II
- Faulty Gas Gauge
- Dumb warner hub and q-trac question
- drive plate to torque converter
- Color codes
- Headers on a Waggy?
- How many leafs? Lift ID help????
- fouling plugs, misfires
- lowering rear window
- Spare tire mount question
- Window Regulator
- Idle mixture screws wager
- Distributor or MC2150
- 80 J10 transfer case: What is it & how does it work
- brake lights not working
- Y-pipe Gasket Help
- Sexy???
- Water Pump Bolt Help
- '88 starter wiring (where is the small wire)
- Steering upgrade help
- Carb Spacer
- Anyone ever use Alumaloy?
- Broken seat
- Is the cs144 all that it's cracked up to be?
- I'm confused on T/Cs. Please help!
- on-board welder ??
- SAE steel bolts grades
- oh great..which clutch?
- Spring bushings
- ok smog in cali
- Gas Leak
- MC2150 Vacuum Line
- Wiring harness for 87 grand ?????
- '76 Q/T dropped front shaft
- 85 vs 86 fomoco 2150
- Few questions Quadtra trac
- np208 tc?
- What muffler are you all running?
- Tranny guys (TH400 deep pan)
- Need Pic of 727 linkage at carb
- Leaks, drains etc. ??
- Tripod Mirror Hardware?
- Timing Mark Setting
- Fast Ammeter Bypass
- Gasket Set for a 230 Tornado OHC
- Dana 44 Axle leaking.
- 360 is ready for work to start
- EGR CTO Switch
- Isuzu rear disc brakes
- J10 Gas Filler Hose?
- Fuel Return line question
- difficult starts 360
- D44 Axle Bearings
- QT will not stay in 4wd
- Fuel guage?
- MC2100 Question Again
- Only starts with a jump
- 225 for T-S D20?
- Paging... Plasticboob
- Got my new muffler/exhaust on...sounds awesome!
- Who's done the S10 Steering Box Mod?
- Pinion Bearing Tips, Tricks, etc..???
- Howell EFI problem
- uh oh...Got a MISS, and it sucks a dollar bill up the exhaust pipe.
- No power :( UPDATED: FIXED :)
- does this belong to one of us???
- where does this go
- gas is not getting to the pump... any ideas?
- Help finding frame specs...
- 78 wagoneer sputters on hill or open throttle
- what pump for winch??
- BASIC VACUUM
- distributor drive gear
- I am going to blow her up with a stick of dynamite in the gas tank!!
- Motor Rattle after acceration
- Hints or tips for hooking up the Vacuum TC shifter?
- Wierd loss of spark
- shorten j20
- why do simple things wreak such havoc??!!
- Replace the TC Chain? Replace the TC? What are you guys doing.
- how do remove sending unit?
- What should I do about exhaust?
- Will a Chevy 12 bolt rear axle fit in a 79' Cherokee W/T without moving the gas tank?
- Lug nuts
- 88 GWag - Air Pump
- Rotor and backing plate removal
- hard starting >>> FIXED!!!
- Body Shop / Oklahoma City
- sealing a steering box
- missing belt
- adjusting manual clutch
- Floor Jack won't lift
- Looping idle
- Which Plugs for a Mildly Built AMC 360?
- 258 w/ 2100 finally running... with more questions
- 258 w/ 2100 finally running... with more questions
- Well, I had 4wd for the first time ever....then CLUNK
- getting black stains off woodgrain moldings 89 GW
- Borg Warner
- CLUNKS WHEN I make tight turns
- 208 Transfercase Weight?
- Windshield wiper chatter... at my wit's end
- New to this forum, introduce myself, and ask a few questions.
- NP229 shift on the fly question?
- 79' Cherokee W/T with a Chevy 350 engine, do I need a fuel return line?
- Rubicon Rocktrac t-case question ... Speedo adapter???
- Cleaning my carb for rebuild
- best replacement floor pans
- Oil Dipstick Install: What Now?
- POR-15 vs Chassis Saver vs Rust Bullet
- Idea I had for my floors
- Identify this bumper?
- BOM number needed mid 80's J20 Dana 60 Please Help! LOL
- Electrical Issues in Instrument Panel!!!
- What's wrong here?
- body lift wows
- Whistling Dixie...whenever the rig decelerates
- Universal Joint Saddles
- Dying need help!
- Installing new steering wheel and boss kit
- random shut offs
- Rear Suspension Air Bags
- 4.27 or 4.56?
- Something was Burning
- excessive fuel consumption....even for a fsj
- Air pump bolt size
- source for QT shift fork shoes
- Can somebody teach me how...
- Oil pump leak
- Q-Trac advice needed ('74 J20)
- Nothing
- 1968 J3000 Column wiring
- No charging Issue
- Door Panels
- 1974 J-20 Stock Wheel Size ?
- need help wiring
- fuel filler hose size 90 GW
- GM Column (New)
- 74 J20 Wheel Compatability
- No Brakes
- 258 Swap Questions
- Engine near death
- Beating the QT horse to death
- Transmission fluid?
- J-20 Receiver Hitch
- Jeep CAD drawings?
- Exhaust routing
- HEI setup
- Transfer case swap : NP 229 out, NP208 in?
- Transfer Case claking noise on deceleration
- Where is your oil strainer?
- Offy intake for a 258
- 85 j20?'s
- I think my timing was just very retarded...
- Belt routing and belt sizes, I think the previous owner messed up.
- Any one running a 390?
- Intake manifold question
- electric tailgate window fix?
- gonna crack the T-case open
- motor mounts
- soft brakes
- Intake Manifold Advice
- Axle Compatability AMC20-J10 D44
- break lines modification?
- Windshield trim install.....
- Need Help Bad On Info For Wiring Harness
- Im parting out my rig - how heavy are the doors and tailgate?
- PCV Hose/EGR Valve
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.