View Full Version : General FSJ Tech
- Shock mounting hardware?
- Help w/ compression test
- TF 727 won't shift into park
- rear d60/drivesahft and gear oil questions.
- Stanky Exhaust
- What aftermarket carb for stock 2 barrel intake?
- Bull's dead...part II
- power seats don't work
- ignition problems
- Distributor replacement??
- Distributor replace/ vacume?
- Which is the best ?
- carb question
- sending unit, and vent gaskets?
- diagram
- replacing ball joints
- Back spacing on Factory wheels
- what type of air conditioner problem do i have
- running 35 with only fender cutting
- prestolite to TFI
- CV joint on front driveshaft exploded questions
- Approximate costs? I need inner bearing/race/seals
- got my new driveshaft in!!!
- What coil should I get?
- EGR Intake ??
- Speedometer gear, housing, o-ring
- Exhaust Valve?
- Knocking sounds??
- Welding a spool
- New Pinion Seals
- Questions Before I Herculine My Floors
- Gremlins
- does anyone know where to get some bumper ideas?
- QT Reduction Unit Bearing Bad?
- NP 229
- Accelerator Pump/Hesitation
- Tailgate Window Switch
- AIR injection question
- Emergency lockout
- 258 Valve Cover Gasket
- Flowkooler PN 1781 Water Pump
- Blown head gasket
- Brakes - a few questions
- Coil???
- 85 front bumper
- Need wiring help!!!!!!
- Time to dive in...
- Rear Brake Hose
- oil pressure
- Waterpump Removal/Install...All done
- need advice, gang (long)
- Spring Bolts
- Dana 20 adapter
- j4000 vin information
- Bumper question
- No spark woes
- Carb questions
- Running problems after new carb...
- 196 willys Wagon Restoration?
- windshield installation
- Engine power and torque figures..
- BJ's Kit
- Install of NP 229?
- smokey joe
- Edelbrock on AMC manifold?
- Quadra Trac / Low Range Question
- door question
- '84 Dodge Ram Charger TC
- alternator belt no a/c
- QT edrive detent spring
- edelbrock shocks (smooth ride?)
- A few ramblings on a w/t swap
- Piston Fittting
- 1 last try
- Bouncing amp meter needle
- Trans Rebuild or Torque Converter ??
- aluminum radiator
- Cages
- adjusting floats on edel carb
- Engines
- A/C bracket for I-6 258?
- Carter(edelbrock) carb with offroad kit
- Advice on one stop shopping for 230ci please
- x-terrains versus baja claw radials
- GVW
- TH400 Q for gsmikie
- where to drill and tap for new temp gauge???
- Gas Fumes
- need a gas filler neck-where to find one?
- oh, boy, I'm gonna get it
- Wandering Wagoneer
- Cruise Control and AC
- Help! bought XJ and have questions
- AMC CB radio
- winter rubber
- spring on driver's side of 727
- Intake question
- motor mounts with hooks...
- calling gsmikie or other tranny pro!!
- Where should I go to get these brake pieces???
- Oem Fog Light Question.
- What to check on a rebuilt engine?
- tailgate switch or dash switch
- New engine
- Torque rating for shock bolts?
- Hi there
- Lift/Tire combos?
- Turbo 400 - gsmikie
- wide track rear lower fenders flares replace
- Power Steering gearbox help, for J-10
- Rear wiring harness
- Yip...Bulls's dead. (Part 3) - Now with Carnage Pic
- 1974 Jeep Wagoneer
- Towing setup
- Noise when I turn the steering wheel
- Can anyone recommend a mechanic in the Las Vegas area?
- lift install ?
- fire extingusher install
- Finally SOA and springs done..
- Will this work for me..............
- Tadsal, UPDATE, tube size (difference) J10 & J20
- motor weight
- camber caster adjustment
- bad idle
- spreadbore, squarebore, huh??
- ideas and opnions on re doing a spring pack
- Oil consumption
- Symptom: okay idle, rough driving...SOLVED (for now)
- Buick 350 dauntless help
- U-joint?
- Rough miss happening, scenario...
- D44 and 10-BOLT the same???
- Spark Knock Kit?
- Long drive on the horizon
- Low range QT, when can I use it?
- Dumb tranny question
- No start
- Fuel leak! Help!!!!!!!!!!!!!!
- Tfi Upgrade (parts needed)
- 4 bolt vs 2 bolt main
- Why is my jeep so dam fast?
- Took it to the Shop Today and Yesterday
- AAL questions, with pics! *Update @ bottom w/ new ?*
- driveshaft angle?
- Driveshaft guru's O.T. but really need help
- Axle questions
- vacuum
- Please advise - Stuck Ignition Switch on Cherokee!!
- Alright Alright, I'll turn my rear spring wedges around.
- tiny stumble
- catalytic converter
- Anyone know the oil pan and exhaust manifold bolt sizes?
- 1977 prestolite ditributor upgrade to a TFI
- operating temp
- Stumbles when you "punch" it...
- Distributor
- dumb newbie questions
- coffin rot
- removing E-brake cable.
- Quickie. Need help with Hub Installations..
- Fender flares?
- Steering box help for J-10
- 1988 GW turn signal problem
- 1988 GW oil pressure/coolant temp gauges
- Grand Wagoneer under hood insulation
- Random Wipers
- suspension question
- HOT gas?!?
- front d44 ID
- Best Vacuum Diagram???
- How to tell diff. between Prestolite and Motorcraft
- Accessory switch location
- t-case 229 and front lockers
- Faulty Float
- 258 Oil Starvation
- Buying Belts, Do I have an 85-amp Alt?
- Steel Gas Tank Repair
- electrical box on passenger fender?
- Joe's Radiation Redux...
- Antifreeze/water mix for aluminum rad?
- distributor swap?
- Paging Dr. Bob Barry! Carb Question?
- Spring guestion
- spring over on a 79 j20
- ignition module
- Another Quickie.. whats do I torque lug nuts to?
- gas tank ona j-truck
- looking at good condition '83 Wag Ltd. w/ hi miles
- Waggy Axle Shaft ?
- Help, question
- Paint Questions
- D44 flat tops & spindles
- Lubrication recommendations
- woodgrain delete
- new thermostat-low temp reading
- WoodGrain Restore
- Need help with tilt steering
- Aluminum Roof Rack idea...
- Paint and interior color codes for 1979 Wagoneer
- what year should i buy
- WINDOW MOTOR?
- Need some help - Jeep won't start
- 88 GW: 4WD light stays on in 2WD
- New Style Dash refit to and older 76 Cherokee
- fuel everywhere
- install question..
- re jetting
- Was the 208 offered in '83 w/258?
- front axle repack help
- need part # for '91 starter relay?
- Helicoil on crank mains?
- replacing distributor questions?
- 360/3speed manual
- Update to "is this a blown head gasket?"(its a broke piston)
- shimming an axle
- sway bar link bushing
- General question on changing belts...
- Anyone use a comp cam 270H?
- can i use my th400 with my 258?
- Starting Trouble
- 727 won't engage
- question
- Anyone running a Truck Avenger?
- 440 GW
- Stalls in reverse? Poor running
- holley help me
- Charcoal Canister?
- 35 inch tires and 3.54 gears
- uh oh! 4wd
- a lovely grinding.
- carb question
- How to put in emergency drive?
- Rear Dana 44 axle issue
- Jeep-n-a-Dodge
- Question about 4 wheel drive
- high output battery for aux lighting
- ATTN: part number gurus
- Finished TFI Upgrade
- uh oh! heat
- Alternator Question
- spark turn key
- CB RADIOS
- EGR Valve 91 GW
- Best way to store a crank?
- need help bad
- Wandering all over the Road
- sway bar position
- are front shackles a good option?
- Won't Start!
- Vac lines...please read
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.